Visualization and Numerical Simulations of Condensing Flow in Small Diameter Channels
Authors:
- 15 March 2018
- journal article
- conference paper
- Published by Taylor & Francis in Heat Transfer Engineering
- Vol. 40 (9-10) , 802-817
Abstract
The understanding of two-phase flow mechanisms during condensation inside small diameter channels is fundamental to design compact condensers. When dealing with small geometries, experimental investigation can be invasive and the measurement of heat transfer coefficients with low uncertainties becomes difficult. For these reasons, numerical simulations by means of the volume of fluid method are an interesting tool to study two-phase flows and they can also be used in support to experimental investigation. In the present work, first steady-state numerical simulations of R134a condensation inside horizontal channels are presented: the results are used to analyse the effect of the diameter (1 mm and 3.4 mm) on the two-phase flow and heat transfer. Since waves occur at the vapor–liquid interface and they cannot be modelled under the hypothesis of steady-state operating conditions, transient simulations (2-D axisymmetric) have also been performed to investigate the influence of waves on the condensation process. The two-phase flow has also been experimentally investigated and visualizations are compared to the numerical results.Keywords
Funding Information
- Italian Ministry of Education ([PRIN2015 - 2015M8S2PA])
This publication has 22 references indexed in Scilit:
- Condensation in a Square Minichannel: Application of the VOF MethodHeat Transfer Engineering, 2013
- The importance of turbulence during condensation in a horizontal circular minichannelInternational Journal of Heat and Mass Transfer, 2012
- Condensation Heat Transfer and Pressure Losses of High- and Low-Pressure Refrigerants Flowing in a Single Circular MinichannelHeat Transfer Engineering, 2011
- Numerical simulation of churn flow in a vertical pipeChemical Engineering Science, 2009
- On the CFD modelling of Taylor flow in microchannelsChemical Engineering Science, 2009
- Condensation in horizontal tubes, part 1: two-phase flow pattern mapInternational Journal of Heat and Mass Transfer, 2003
- Condensation in horizontal tubes, part 2: new heat transfer model based on flow regimesInternational Journal of Heat and Mass Transfer, 2003
- Two-phase flow regimes in round, square and rectangular tubes during condensation of refrigerant R134aInternational Journal of Refrigeration, 2003
- Two-equation eddy-viscosity turbulence models for engineering applicationsAIAA Journal, 1994
- A continuum method for modeling surface tensionJournal of Computational Physics, 1992