Two Rectangular Loops Fed in Series for Broadband Circular Polarization and Impedance Matching
Authors:
- 5 April 2004
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 52 (2) , 551-554
Abstract
Two rectangular wire loops above an infinite ground plane are investigated for broadband circular polarization and impedance matching. Each rectangular loop is connected to each end of a short dipole fed by a coaxial cable through the ground plane. One gap on each loop is introduced to get circular polarization and the gap position controls the sense of circular polarization. The position of the gap, the length of the short dipole, the height of the loop above the ground plane and the shape of the rectangle are very important to get a good axial ratio (AR) and voltage standing-wave ratio (VSWR). The AR bandwidth (/spl les/3 dB) and the VSWR bandwidth (/spl les/2) are 18% and 22%, respectively. The measured and computed results are in good agreement.Keywords
This publication has 8 references indexed in Scilit:
- Analysis and design of L-probe proximity fed-patch antennasIEEE Transactions on Antennas and Propagation, 2001
- Design of broadband probe-fed plate antenna with stubIEE Proceedings - Microwaves, Antennas and Propagation, 2001
- Broadband circularly polarised slot loop antennafed by three-stub hybrid couplerElectronics Letters, 1999
- Square-ring microstrip antenna with a cross strip for compact circular polarization operationIEEE Transactions on Antennas and Propagation, 1999
- Circularly polarised wire antenna with a dual rhombic loopIEE Proceedings - Microwaves, Antennas and Propagation, 1998
- A monopole loaded with a loop antennaIEEE Transactions on Antennas and Propagation, 1996
- The cross antenna: a new low-profile circularly polarized radiatorIEEE Transactions on Antennas and Propagation, 1990
- Circularly polarised travelling-wave printed line antennasElectronics Letters, 1989