Film Cooling Effectiveness and Heat Transfer on the Trailing Edge Cutback of Gas Turbine Airfoils With Various Internal Cooling Designs
Authors:
- 1 February 2005
- journal article
- Published by Wiley in Journal of Turbomachinery
- Vol. 128 (1) , 196-205
Abstract
The present study deals with trailing edge film cooling on the pressure side cutback of gas turbine airfoils. Before being ejected tangentially onto the inclined cut-back surface the coolant air passes a partly converging passage that is equipped with turbulators such as pin fins and ribs. The experiments are conducted in a generic setup and cover a broad variety of internal cooling designs. A subsonic atmospheric open-loop wind tunnel is utilized for the tests. The test conditions are characterized by a constant Reynolds number of Rehg=250000, a turbulence intensity of Tuhg=7%, and a hot gas temperature of Thg=500K. Due to the ambient temperature of the coolant, engine realistic density ratios between coolant and hot gas can be realized. Blowing ratios cover a range of 0.20<M<1.25. The experimental data to be presented include discharge coefficients, adiabatic film cooling effectiveness, and heat transfer coefficients in the near slot region (x∕H<15). The results clearly demonstrate the strong influence of the internal cooling design and the relatively thick pressure side lip (t∕H=1) on film cooling performance downstream of the ejection slot.Keywords
This publication has 22 references indexed in Scilit:
- Influence of Free-Stream Turbulence on Turbulent Boundary Layer Heat Transfer and Mean Profile Development, Part I—Experimental DataJournal of Heat Transfer, 1983
- The Effectiveness of Film Cooling With Three-Dimensional Slot GeometriesJournal of Engineering for Power, 1971
- The prediction of wall temperature in the presence of film coolingInternational Journal of Heat and Mass Transfer, 1971
- Film Cooling1971
- An experimental investigation of the influence of slot-lip-thickness on the impervious-wall effectiveness of the uniform-density, two-dimensional wall jetInternational Journal of Heat and Mass Transfer, 1969
- The influence of foreign gas injection and slot geometry on film cooling effectivenessInternational Journal of Heat and Mass Transfer, 1969
- Film Cooling Slots: The Importance of Lip Thickness and Injection AngleJournal of Mechanical Engineering Science, 1969
- The dependence of the impervious wall effectiveness of a two-dimensional wall-jet on the thickness of the upper lip boundary layerInternational Journal of Heat and Mass Transfer, 1967
- Effectiveness and Heat Transfer for a Turbulent Boundary Layer With Tangential Injection and Variable Free-Stream VelocityJournal of Heat Transfer, 1962
- Heat Transfer and Effectiveness for a Turbulent Boundary Layer With Tangential Fluid InjectionJournal of Heat Transfer, 1960