Morphology and crystalline properties of impact‐modified polypropylene blends
- 17 June 2008
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 48 (8) , 1476-1486
Abstract
Isotactic polypropylene has been reactively blended with an ethylene‐octene copolymer so as to improve mechanical and rheological properties. Free radical polymerization of styrene and a multifunctional acrylate during melt extrusion has resulted in the formation of unique features in both amorphous and crystalline phases. Transmission electron microscopy images show that the elastomer domains are less than 200 nm in diameter, whereas grafting leads to the appearance of clusters of polymeric particles, ranging in size from several nanometers up to 200 nm. Differential scanning calorimetry (DSC) shows that grafting creates lamellar crystals that melt at much lower temperatures and recrystallize at much higher temperatures than binary blends. From wide angle X‐ray diffraction and DSC, grafting has been shown to limit the maximum crystal size and perfection, as well as broaden the size distribution of the crystals. Grafting causes significant changes in the α crystalline phase of polypropylene and promotes the formation of the β phase. Scanning electron microscopy reveals a unique cross‐hatch structure of small crystals in the reactive blend, with tangential and radial lamellae appearing as crosslinked material of about the same aspect ratio. Polarized light microscopy gives evidence that grafting and branching within this blend causes a gelation‐like recrystallization. POLYM. ENG. SCI., 2008. © 2008 Society of Plastics EngineersKeywords
This publication has 60 references indexed in Scilit:
- Structure of polypropylene crystallized in confined nanolayersJournal of Polymer Science Part B: Polymer Physics, 2004
- Radical reactions on polypropylene in the solid stateProgress in Polymer Science, 2002
- In Situ FTIR Spectroscopic Study of the Conformational Change of Isotactic Polypropylene during the Crystallization ProcessThe Journal of Physical Chemistry B, 2001
- Styrene grafting onto a polyolefin in an internal mixer and a twin‐screw extruder: Experiment and kinetic modelPolymer Engineering & Science, 2001
- Effect of Reaction Rate on Morphological Change of Reactive BlendsMacromolecules, 2000
- Correlation of Rheology and Light Scattering in Isotactic Polypropylene during Early Stages of CrystallizationMacromolecules, 1999
- Mixing and morphological transformations in the compounding process for polymer blends: The phase inversion mechanismPolymer Engineering & Science, 1995
- Crosslinking of polypropylene–polyethylene blends by peroxide and the effect of pentaerythritol tetrallyl etherJournal of Applied Polymer Science, 1989
- Ductile-to-brittle transition of rubber-modified polypropyleneJournal of Materials Science, 1988
- Heterogeneous nucleation in the crystallization of polyolefins. III. Theory and mechansimJournal of Polymer Science: Polymer Physics Edition, 1973