Analysis of the natural frequency of a quartz double-end tuning fork with a new deformation model
Authors:
- 27 April 2016
- journal article
- research article
- Published by IOP Publishing in Journal of Micromechanics and Microengineering
- Vol. 26 (6) , 065006
Abstract
The quartz double-end tuning fork is composed of two parallel slender beams with their ends fixed to the proof masses, both ends of which are clamped. The structure is made of a quartz wafer which is anisotropic in stiffness. In anti-phase mode the two slender parallel beams vibrate in opposite directions and can be modelled as an Euler beam. The twist moments caused by the slender beams on the proof mass make the cross-section of the proof mass deform into a warped surface. The objective of this research is to establish the warping deformation model so that we can build up the equation of motion for anisotropic stiffness by using Hamilton's principle and then perform theoretical analysis. The more realistic warping displacement leads the natural frequency closer to the true one. The purpose of the proof mass is to modulate the frequencies and mode shape of tuning fork beams. The advantage of anti-phase mode is that the centre of mass in unchanged during motion so that the system has a higher signal-to-noise ratio. The theoretically obtained frequency is compared with the experimental one and that obtained by the finite element method.Keywords
This publication has 25 references indexed in Scilit:
- Application of piezoelectric tuning forks in liquid viscosity and density measurementsSensors and Actuators B: Chemical, 2011
- Dynamics of quartz tuning fork force sensors used in scanning probe microscopyNanotechnology, 2009
- SEMI-ANALYTICAL APPROACH TO THE NON-LINEAR DYNAMIC RESPONSE PROBLEM OF S–S AND C–C BEAMS AT LARGE VIBRATION AMPLITUDES PART I: GENERAL THEORY AND APPLICATION TO THE SINGLE MODE APPROACH TO FREE AND FORCED VIBRATION ANALYSISJournal of Sound and Vibration, 1999
- Etch rates of crystallographic planes inZ-cut quartz - experiments and simulationJournal of Micromechanics and Microengineering, 1998
- Modelling and optimization of micromachined silicon resonatorsJournal of Micromechanics and Microengineering, 1995
- A piezoelectrically operated optical chopper by quartz micromachiningJournal of Microelectromechanical Systems, 1995
- Anisotropic etching of Z-cut quartzJournal of Micromechanics and Microengineering, 1993
- Quartz: a material for microdevicesJournal of Micromechanics and Microengineering, 1991
- Large-amplitude free vibrations of beams—A discussion on various formulations and assumptionsJournal of Sound and Vibration, 1990
- Elastic and Piezoelectric Constants of Alpha-QuartzPhysical Review B, 1958