The Discovery of Fracture Tip-Driven Stress Concentration: A Key Contributor to Casing Deformation in Horizontal Wells
Open Access
Abstract
Casing deformation (CD) is generally believed to be caused by the slip of fractures in the strata and its shear effects on horizontal wells. However, the casing deformation mode based on this theory cannot fully match the measurement data, and the differential deformation characteristics and the mechanism behind this phenomenon are not completely clear. To elucidate the mechanisms of CD and enhance prevention and control measures, the CD modes in Shunan Block were identified and deformation mechanisms of these modes were comprehensively investigated. Our research shows the following: (1) Under the mechanism of penetrating fracture shear deformation, CD exhibit obvious shear deformation, and the natural fractures near the intersection point with the wellbore are prone to form a higher risk of deformation. (2) Natural fractures with tips approaching the wellbore experience intense stress concentration (1.6 times higher than shear stress) during activation, resulting in compression and asymmetrical CD. (3) The shear deformation induced by penetrating fractures is 15.52 mm, while the fracture tip-induced compression deformation demonstrates a substantially greater magnitude at 44.17 mm. This compressive deformation exceeds the shear deformation by a factor of approximately 2.85. (4) The stress concentration at the fracture tip is highly sensitive to the injection rate. Hence, adherence to the “avoiding stress concentration” principle is crucial in hydraulic fracturing operations. The conclusion indicates that in addition to penetrating fracture shear deformation, fracture tip compression deformation is another significant mechanism that causes CD. This research finding can offer theoretical guidance for developing effective measures to prevent and control CD in the exploitation of deep shale gas.Keywords
Funding Information
- China National Petroleum Corporation’s key applied science and technology project (2023ZZ21YJ01)
This publication has 41 references indexed in Scilit:
- A new insight into casing shear failure induced by natural fracture and artificial fracture slipEngineering Failure Analysis, 2022
- Study on the effect of cemented natural fractures on hydraulic fracture propagation in volcanic reservoirsEnergy, 2022
- Analysis of casing deformation failure mechanism based on fault slipEngineering Failure Analysis, 2021
- Numerical investigation of casing shear deformation due to fracture/fault slip during hydraulic fracturingEnergy Science & Engineering, 2020
- A new numerical method for evaluating the variation of casing inner diameter after strike‐slip fault sliding during multistage fracturing in shale gas wellsEnergy Science & Engineering, 2019
- Mechanism of casing failure during hydraulic fracturing: Lessons learned from a tight-oil reservoir in ChinaEngineering Failure Analysis, 2019
- Numerical investigations of the fracture geometry and fluid distribution of multistage consecutive and alternative fracturing in a horizontal wellComputers and Geotechnics, 2017
- Fractal characteristics of shales from a shale gas reservoir in the Sichuan Basin, ChinaFuel, 2014
- Shale gas reservoir characterisation: A typical case in the southern Sichuan Basin of ChinaEnergy, 2011
- Using a three-dimensional concept in a two-dimensional model to predict accurate hydraulic fracture dimensionsJournal of Petroleum Science and Engineering, 1995