Light Transmittance and Depth of Cure of a Bulk Fill Composite Based on the Exposure Reciprocity Law
Open Access
- 1 February 2021
- journal article
- research article
- Published by FapUNIFESP (SciELO) in Brazilian Dental Journal
- Vol. 32 (1) , 78-84
Abstract
The objective of this study was to evaluate the effect of the exposure reciprocity law of a multi-wave light-emitting diode (LED) on the light transmittance (LT), depth of cure (DOC) and degree of conversion in-depth (DC) of a bulk fill composite. A bulk fill composite (EvoCeram® bulk fill, Ivoclar Vivadent) was photoactivated using the multi-wave LED (VALO™ Cordless, Ultradent). The LED was previously characterized using a spectrophotometer to standardize the time of exposure when using the Standard or Xtra-Power modes with the same radiant exposure of 20J/cm2. LT was evaluated through samples of the bulk fill composite every millimeter till 4 mm in-depth. DOC was evaluated according to the ISO 4049. DC of the central longitudinal cross-section from each sample of the DOC test was mapped using FT-NIR microscopy. Data were statistically analyzed according to the experimental design (α=0.05; ß=0.2). The radiant exposure in the violet wavelength range for Standard and Xtra-Power was 4.5 and 5.0 J/cm2, respectively; for the blue wavelength range the radiant exposure for Standard and Xtra-Power was 15.5 and 15.0 J/cm2, respectively. There was no statistical difference in the DOC using Standard or Xtra-Power light-curing modes, but the DOC was lower than the claimed by the manufacturer (4 mm). The DC was not significantly affected by the light-curing mode up to 4 mm in depth (p>0.05). According to exposure reciprocity law, the reduction in exposure time using the same radiant exposure did not affect the depth of cure of the bulk fill composite.Keywords
This publication has 22 references indexed in Scilit:
- Light-emitting Diode Beam Profile and Spectral Output Influence on the Degree of Conversion of Bulk Fill CompositesOperative Dentistry, 2017
- The effect of combining photoinitiator systems on the color and curing profile of resin-based compositesDental Materials, 2016
- Effects of radiant exposure and wavelength spectrum of light-curing units on chemical and physical properties of resin cementsRestorative Dentistry & Endodontics, 2016
- Effect of different photoinitiators and reducing agents on cure efficiency and color stability of resin-based composites using different LED wavelengthsJournal of Dentistry, 2015
- Light Curing Explored in HalifaxOperative Dentistry, 2014
- The effect of ultra-fast photopolymerisation of experimental composites on shrinkage stress, network formation and pulpal temperature riseDental Materials, 2014
- Ultra-fast light-curing resin composite with increased conversion and reduced monomer elutionDental Materials, 2014
- Photoinitiator type and applicability of exposure reciprocity law in filled and unfilled photoactive resinsDental Materials, 2011
- The initiating radical yields and the efficiency of polymerization for various dental photoinitiators excited by different light curing unitsDental Materials, 2006
- Molar extinction coefficients and the photon absorption efficiency of dental photoinitiators and light curing unitsJournal of Dentistry, 2005