RETRACTED: Investigation of structure‐performance properties of a special type of polysulfone blended membranes
- 11 July 2018
- journal article
- retracted article
- Published by Wiley in Polymers for Advanced Technologies
- Vol. 29 (10) , 2690-2700
Abstract
Membranes require superior mechanical strength due to applied harsh conditions. The mechanical properties of membranes decrease with increasing hydrophilicity of its elements. In this study, mechanical properties were investigated for two special blended membranes which were made by blending polysulfone with (polysulfone‐g‐poly (n‐butylacrylate) and polysulfone‐g‐poly (tert‐butylacrylate) as components. All of the prepared membranes were characterized by differential scanning calorimeter, thermal gravimetric analysis, field emission scanning electron microscope, and atomic electron microscope and were investigated in terms of pure water flux, water contact angle, molecular weight cut off, and morphology. It was found that water contact angle decreased from 73.6° which belongs to neat membrane decreased to 46° for blended membranes containing higher amounts of copolymers; however, the pure water flux increased with increasing copolymer content considerably compared with the neat membrane. Also, molecular weight cut off increased aggressively. Furthermore, mechanical properties including tensile strength, Young modulus, and elongation at break were measured and compared with the neat polysulfone membrane. Results showed that the tensile strength and modulus decreased with an increase in the copolymers content, despite the increase in the elongation at break. The effect of applied pressure on the membrane structure and also bursting strength were studied, and it has been proved that not only the structure of the membranes but also their performance is strongly affected by the composition of the membranes.Keywords
This publication has 32 references indexed in Scilit:
- Enhancing the performance of PVDF membranes by hydrophilic surface modification via amine treatmentSeparation and Purification Technology, 2017
- Preparation of hydrophilic and antifouling polysulfone ultrafiltration membrane derived from phenolphthalin by copolymerization methodApplied Surface Science, 2017
- Grafting of diallyldimethylammonium chloride on graphene oxide by RAFT polymerization for modification of nanocomposite polysulfone membranes using in water treatmentChemical Engineering Journal, 2017
- Impact of synthesized amino alcohol plasticizer on the morphology and hydrophilicity of polysulfone ultrafiltration membraneJournal of Membrane Science, 2017
- Polysulfone/sulfonated polysulfone alloy membranes with an improved performance in processing mariculture wastewaterChemical Engineering Journal, 2016
- Polymeric membranes: Surface modification for minimizing (bio)colloidal foulingAdvances in Colloid and Interface Science, 2014
- Improving the thermal and mechanical properties of polysulfone by incorporation of graphene oxideComposites Part B: Engineering, 2014
- Modification of polyethersulfone membranes – A review of methodsProgress in Materials Science, 2013
- Modification of polyethersulfone membrane by blending semi-interpenetrating network polymeric nanoparticlesJournal of Membrane Science, 2011
- Chemical modification of polyethersulfone nanofiltration membranes: A reviewJournal of Applied Polymer Science, 2009