Diffusion-controlled reference material for VOC emissions testing: proof of concept
Authors:
- 10 September 2010
- journal article
- research article
- Published by Hindawi Limited in Indoor Air
- Vol. 20 (5) , 424-433
Abstract
Because of concerns about indoor air quality, there is growing awareness of the need to reduce the rate at which indoor materials and products emit volatile organic compounds (VOCs). To meet consumer demand for low emitting products, manufacturers are increasingly submitting materials to independent laboratories for emissions testing. However, the same product tested by different laboratories can result in very different emissions profiles because of a general lack of test validation procedures. There is a need for a reference material that can be used as a known emissions source and that will have the same emission rate when tested by different laboratories under the same conditions. A reference material was created by loading toluene into a polymethyl pentene film. A fundamental emissions model was used to predict the toluene emissions profile. Measured VOC emissions profiles using small‐chamber emissions tests compared reasonably well to the emissions profile predicted using the emissions model, demonstrating the feasibility of the proposed approach to create a diffusion‐controlled reference material. Practical Implications To calibrate emissions test chambers and improve the reproducibility of VOC emission measurements among different laboratories, a reference material has been created using a polymer film loaded with a representative VOC. Initial results show that the film’s VOC emission profile measured in a conventional test chamber compares well to predictions based on independently determined material/chemical properties and a fundamental emissions model. The use of such reference materials has the potential to build consensus and confidence in emissions testing as well as ‘level the playing field’ for product testing laboratories and manufacturers.Keywords
This publication has 21 references indexed in Scilit:
- An Experimental Study for Examining the Effects of Environmental Conditions on Diffusion Coefficient of VOCs in Building MaterialsCLEAN – Soil, Air, Water, 2009
- What is IAQ?Indoor Air, 2006
- An investigation of the relationship between air emissions of volatile organic compounds and the incidence of cancer in Indiana countiesEnvironmental Research, 2006
- Effects of pollution from personal computers on perceived air quality, SBS symptoms and productivity in officesIndoor Air, 2004
- An analytical model for VOCs emission from dry building materialsAtmospheric Environment, 2004
- Review of indoor emission source models. Part 1. OverviewEnvironmental Pollution, 2002
- Predicting the Emission Rate of Volatile Organic Compounds from Vinyl FlooringEnvironmental Science & Technology, 2002
- Measuring partition and diffusion coefficients for volatile organic compounds in vinyl flooringAtmospheric Environment, 2001
- Sorption behaviour of volatile organic compounds on material surfaces ? The influence of combinations of compounds and materials compared to sorption of single compounds on single materialsEnvironment International, 1999
- Adsorption Modelling for Building Contaminant Dispersal AnalysisIndoor Air, 1991