Novel Zero-Voltage Zero-Current Transition Buck Converter With Minimal Impact of Active Auxiliary Cell on Overall Dynamics
Authors:
Open Access
- 5 January 2023
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 11, 3008-3023
Abstract
This paper presents a novel zero-voltage zero-current transition DC/DC buck converter, which uses an active auxiliary resonant network to achieve soft switching operation of semiconductor switches and soft-recovery of power diodes over wide output power range and offers high efficiency. The auxiliary cell in the proposed converter does not cause any additional current stress on the semiconductor switches and has minimal impact on overall dynamics of the converter. Steady-state performance of the converter has been presented with detailed theoretical analysis of all operating modes. The design of auxiliary cell components and development of small signal model of the converter have been carried out from the mathematical equations depicting its dynamic behaviour. A closed loop voltage mode controller with a type III compensator has been developed for the converter to achieve the desired transient response under the influence of external disturbances. Power loss analysis and superiority of the proposed converter over other conventional configurations are also presented here. Finally, soft-switching behaviour and step-input transient response of the converter are verified by hardware experimentation on a150W, 100 kHz prototype model. The experimental measurements have successfully validated the theoretically predicted behaviour of the converter.Keywords
This publication has 26 references indexed in Scilit:
- PWM Switched Capacitor Converter With Switched-Capacitor-Inductor Cell for Adjustable High Step-Down Voltage ConversionIEEE Transactions on Power Electronics, 2018
- Development of an Improved Tristate Buck–Boost Converter With Optimized Type-3 ControllerIEEE Journal of Emerging and Selected Topics in Power Electronics, 2017
- Limitations on dominant pole pair selection with continuous PI and PID controllers2016
- Design and implementation of type‐II and type‐III controller for DC–DC switched‐mode boost converter by using K ‐factor approach and optimisation techniquesIET Power Electronics, 2016
- Topology Derivation and Generalized Analysis of Zero-Voltage-Switching Synchronous DC-DC Converters with Coupled InductorsIEEE Transactions on Industrial Electronics, 2016
- Zero‐voltage‐switching buck converter with low‐voltage stress using coupled inductorIET Power Electronics, 2016
- Step-Down Converter With Efficient ZVS Operation With Load VariationIEEE Transactions on Industrial Electronics, 2013
- An Improved Soft-Switching Buck Converter With Coupled InductorIEEE Transactions on Power Electronics, 2013
- Analysis and Design of a Zero-Current Switching Forward Converter With Simple Auxiliary CircuitIEEE Transactions on Power Electronics, 2010
- Reduction of power converter EMI emission using soft-switching techniqueIEEE Transactions on Electromagnetic Compatibility, 1998