Numerical Simulation of the Deflagration-to-Detonation Transition in Inhomogeneous Mixtures
Open Access
- 1 January 2014
- journal article
- research article
- Published by Wiley in Journal of Combustion
- Vol. 2014, 1-15
Abstract
In this study the hazardous potential of flammable hydrogen-air mixtures with vertical concentration gradients is investigated numerically. The computational model is based on the formulation of a reaction progress variable and accounts for both deflagrative flame propagation and autoignition. The model is able to simulate the deflagration-to-detonation transition (DDT) without resolving all microscopic details of the flow. It works on relatively coarse grids and shows good agreement with experiments. It is found that a mixture with a vertical concentration gradient can have a much higher tendency to undergo DDT than a homogeneous mixture of the same hydrogen content. In addition, the pressure loads occurring can be much higher. However, the opposite effect can also be observed, with the decisive factor being the geometric boundary conditions. The model gives insight into different modes of DDT. Detonations occurring soon after ignition do not necessarily cause the highest pressure loads. In mixtures with concentration gradient, the highest loads can occur in regions of very low hydrogen content. These new findings should be considered in future safety studies.Keywords
Funding Information
- German Federal Ministry of Economics and Technology (1501338)
This publication has 48 references indexed in Scilit:
- Computational validation of the EPR™ combustible gas control systemNuclear Engineering and Design, 2012
- Releases from hydrogen fuel-cell vehicles in tunnelsInternational Journal of Hydrogen Energy, 2012
- Flame acceleration and explosion safety applicationsProceedings of the Combustion Institute, 2011
- The effect of pressure boundary rupture rate on spontaneous ignition of pressurized hydrogen releaseJournal of Loss Prevention in the Process Industries, 2009
- Numerical simulation on the diffusion of hydrogen due to high pressured storage tanks failureJournal of Loss Prevention in the Process Industries, 2009
- CFD modelling of hydrogen release, dispersion and combustion for automotive scenariosJournal of Loss Prevention in the Process Industries, 2008
- Origins of the deflagration-to-detonation transition in gas-phase combustionCombustion and Flame, 2007
- Simulation of hydrogen deflagration and detonation in a BWR reactor buildingNuclear Engineering and Design, 2002
- Procedure and tools for deterministic analysis and control of hydrogen behavior in severe accidentsNuclear Engineering and Design, 2000
- Instabilities, Pattern Formation, and Turbulence in FlamesAnnual Review of Fluid Mechanics, 1983