A signal processing method for continuous mud pressure wave signals in logging-while-drilling systems
Authors:
- 15 December 2023
- journal article
- research article
- Published by European Society of Computational Methods in Sciences and Engineering in Journal of Computational Methods in Sciences and Engineering
- Vol. 23 (6) , 3027-3035
Abstract
For signal transmission of mud pressure waves in logging-while-drilling systems, as more measurement parameters are adopted, the conventional signal transmission rate of approximately 1 bps cannot meet the requirements of parameter uploading. Transmission rates greater than 10 bps are widely used by current Chinese and international enterprises in their continuous wave transmission systems. Due to the increasing transmission rates, a conventional single-channel pressure sensor cannot effectively identify the key features of an original signal with a low signal-to-noise ratio at a high transmission rate. This issue results in a low success rate for pressure wave recognition and decoding. This paper addresses a method for the collection of pressure wave signals using multi-channel pressure sensors through the analysis of the signal transmission changes of mud pressure waves with well depths and echo interference caused by drilling rod reflection. In this research, numerical simulation and experimental verification were used to calculate the cross-correlations of the multi-channel signals to effectively remove interference noises such as reflective waves and improve the signal-to-noise ratio of the original signal. The results showed that this method could effectively improve the SNR after the wave filtering of the original pressure wave. The characteristics of the continuous mud pressure wave signals were analysed using a circulation test. A corresponding band-pass filter was designed to remove pump noises to restore the sinusoidal pressure wave signal required by the original transmission rules.Keywords
This publication has 12 references indexed in Scilit:
- A continuous phase-frequency modulation technique and adaptive pump noise cancellation method of continuous-wave signal over mud telemetry channelDigital Signal Processing, 2021
- Design of a downlink algorithm for rotary steering (logging while drilling) systemsApplied Geophysics, 2020
- The Design of Logging while Drilling’s Data Acquisition & Processing System based on High Data Rate Miller code2020
- The Process of High-Data-Rate Mud Pulse Signal in Logging While Drilling SystemMathematical Problems in Engineering, 2020
- Parametric study on pump noise processing method of continuous wave mud pulse signal based on dual-sensorJournal of Petroleum Science and Engineering, 2019
- Adaptive dual-sensor noise cancellation method for continuous wave mud pulse telemetryJournal of Petroleum Science and Engineering, 2018
- Differential signal extraction for continuous wave mud pulse telemetryJournal of Petroleum Science and Engineering, 2017
- Research on MWD Mud Pulse Signal Waveform Identification AlgorithmApplied Mechanics and Materials, 2014
- Continuous wavelet transformation: A novel approach for better detection of mud pulsesJournal of Petroleum Science and Engineering, 2013
- New Mud Pulse Telemetry Techniques for Deepwater Applications and Improved Real-Time Data Capabilities2001