Grounded-capacitor first-order filter employing single DVCC
Authors:
- 1 May 2011
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 401-404
Abstract
A new first-order voltage-mode filter employing minimum active and passive components is proposed. The proposed configuration employs one differential voltage current conveyor, one grounded capacitor and one resistor. It maintains the following advantageous: (i) employment of only one current conveyor, (ii) employment of only one grounded capacitor, (iii) employment of only one resistor, (iv) simultaneous realization of voltage-mode first-order lowpass, highpass and allpass filter responses from the same configuration, (v) no need to impose component choice conditions and (vi) low active and passive sensitivity performances. HSPICE simulation results using TSMC 0.18 μm 1P6M CMOS process and ±0.9V supply voltages validate the theoretical predictions.Keywords
This publication has 17 references indexed in Scilit:
- Voltage-mode highpass, bandpass and lowpass filters using two DDCCsInternational Journal of Electronics, 2004
- All-pass filters based on CCII− and CCCII−International Journal of Electronics, 2004
- Supplementary all-pass sections with reduced number of passive elements using a single current conveyorInternational Journal of Electronics, 2001
- Novel first order all-pass sections using a single CCIIIInternational Journal of Electronics, 2001
- Simple first order all-pass section using a single CCIIInternational Journal of Electronics, 2000
- Grounded-capacitor current-mode SRCO: Novel applicationof DVCCCElectronics Letters, 2000
- All-pass filters using a single current conveyorInternational Journal of Electronics, 1999
- Generation of current conveyor-based all-pass filters from op amp-based circuitsIEEE Transactions on Circuits and Systems II: Analog and Digital Signal Processing, 1997
- Novel CMOS differential voltage current conveyor and its applicationsIEE Proceedings - Circuits, Devices and Systems, 1997
- Realization of current mode all-pass networks using a current conveyorIEEE Transactions on Circuits and Systems, 1990