An Analysis of Latch Comparator Offset Due to Load Capacitor Mismatch
Authors:
- 19 December 2006
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Analog and Digital Signal Processing
- Vol. 53 (12) , 1398-1402
Abstract
This brief analyzes the effect of load capacitor mismatch on the offset of a regenerative latch comparator. Two analytical models are presented and compared with HSpice simulations. Our results indicate that in a typical 0.18-mum CMOS latch, a capacitive imbalance of only 1 fF can lead to offsets of several tens of millivoltsKeywords
This publication has 9 references indexed in Scilit:
- A background comparator calibration technique for flash analog-to-digital convertersIEEE Transactions on Circuits and Systems I: Regular Papers, 2005
- A dynamic analysis of a latched CMOS comparator2004
- Speed-power-accuracy tradeoff in high-speed CMOS ADCsIEEE Transactions on Circuits and Systems II: Analog and Digital Signal Processing, 2002
- The impact of intrinsic device fluctuations on CMOS SRAM cell stabilityIEEE Journal of Solid-State Circuits, 2001
- Low-power area-efficient high-speed I/O circuit techniquesIEEE Journal of Solid-State Circuits, 2000
- Analysis of the behavior of a dynamic latch comparatorIEEE Transactions on Circuits and Systems I: Regular Papers, 1998
- Design techniques for high-speed, high-resolution comparatorsIEEE Journal of Solid-State Circuits, 1992
- Mismatch sensitivity of a simultaneously latched CMOS sense amplifierIEEE Journal of Solid-State Circuits, 1991
- Matching properties of MOS transistorsIEEE Journal of Solid-State Circuits, 1989