Hot isostatic pressing synthesis and mechanical properties of Al/Al–Cu–Fe composite materials
- 1 April 2008
- journal article
- Published by Springer Nature in Journal of Materials Research
- Vol. 23 (4) , 904-910
Abstract
Metal-matrix composites are produced from Al powder and 30 vol% of icosahedral Al–Cu–Fe quasi-crystalline particles using a hot isostatic pressing technique. It is demonstrated that the initial icosahedral phase is transformed into the ω-Al70Cu20Fe10 tetragonal phase during the hot isostatic pressing (HIP) process. The mechanical properties of the composite were evaluated over the temperature range 293 to 773 K by performing compression tests at constant strain rate. The temperature dependence of the yield stress gives evidence of two temperature regimes with a transition temperature at approximately 423 K. Strain-rate sensitivity measurements support the change in rate-controlling deformation mechanisms at this temperature. It is proposed that cross-slip and/or climb mechanism control plastic flow. Finally, it is suggested that the phase transformation of the particle contributes positively to the improvement of the mechanical properties.Keywords
This publication has 31 references indexed in Scilit:
- Consolidation effects on tensile properties of an elemental Al matrix compositeMaterials Science and Engineering: A, 2004
- Tensile properties of nanometric Al2O3 particulate-reinforced aluminum matrix compositesMaterials Chemistry and Physics, 2004
- Microstructures and mechanical properties of pure Al matrix composites reinforced by Al;Cu;Fe alloy particlesMaterials Science and Engineering: A, 2003
- Synthesis and mechanical properties of mechanically alloyed Al-Cu-Fe quasicrystalline compositesPhilosophical Magazine, 2003
- Comparison of Al-Cu-Fe quasicrystalline particle reinforced Al composites fabricated by conventional casting and extrusionJournal of Materials Science, 2001
- Metal matrix composites reinforced by gas-atomised Al-Cu-Fe powdersMaterials Science and Engineering: A, 2000
- The fracture toughness and fatigue behavior of DRAJOM, 1999
- Consumption of SiC whiskers by the Al–SiC reaction in aluminium-matrix SiC whisker compositesJournal of Materials Chemistry, 1996
- Particle reinforced aluminium and magnesium matrix compositesInternational Materials Reviews, 1994
- Micro- and macrostructural factors in DRA fracture resistanceJOM, 1993