Modeling deformation and failure in AlSi-polyester abradable sealcoating material using microstructure-based finite element simulation
Authors:
- Jiahao ChengJCJiahao Cheng
- Xiaohua HuXHXiaohua Hu
- Drew LancasterDLDrew Lancaster
- Xin SunXin Sun
- William JoostWJWilliam Joost
Open Access
- 30 May 2022
- journal article
- research article
- Published by Elsevier in Materials & Design
- Vol. 219
Abstract
No abstract availableKeywords
This publication has 34 references indexed in Scilit:
- Numerical-Experimental Comparison in the Simulation of Rotor/Stator Interaction Through Blade-Tip/Abradable Coating ContactJournal of Engineering for Gas Turbines and Power, 2012
- Low-thermal-conductivity plasma-sprayed thermal barrier coatings with engineered microstructuresActa Materialia, 2006
- A unified model for stiffness modulus of amorphous polymers across transition temperatures and strain ratesPolymer, 2005
- A formulation of the cooperative model for the yield stress of amorphous polymers for a wide range of strain rates and temperaturesPolymer, 2005
- Effects of pores and interfaces on effective properties of plasma sprayed zirconia coatingsActa Materialia, 2003
- Comprehensive microstructural characterization and predictive property modeling of plasma-sprayed zirconia coatingsActa Materialia, 2003
- Modeling of the competition between shear yielding and crazing in glassy polymersJournal of the Mechanics and Physics of Solids, 2000
- Using the finite element method to compute the influence of complex porosity and inclusion structures on the thermal and electrical conductivityInternational Journal of Heat and Mass Transfer, 1997
- Evolution of plastic anisotropy in amorphous polymers during finite strainingInternational Journal of Plasticity, 1993
- Ductile–brittle transition in polymersJournal of Applied Polymer Science, 1984