Fabrication of SiC and Al2O3 foams by replica method for premixed porous burner application
Authors:
- M. R. M. NawiMNM. R. M. Nawi
- 11 January 2019
- conference paper
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 2059 (1) , 020059
Abstract
This article presents the preparation of two-layer ceramic foams with different pore sizes for porous media combustion (PMC) application and the analysis of combustion characteristics. The two-layer of ceramic foams are required for flame stabilization as stated by previous works which consists of the following: combustion layer with larger pore size and preheat/mixing layer with smaller pore size. Aluminum oxides (Al2O3) and silicon carbide (SiC) are the materials for preheat/mixing and combustion layers, respectively. Both Al2O3 and SiC foams were prepared by using the replica method, where the polyurethane sponge is soaked in each Al2O3 and SiC slurry. Sintering temperature at 1200°C was found adequate for the ceramic foams to be strong enough for handling and use in combustion. The two-layer ceramic foams were tested in PMC using premixed burner with liquified petroleum gas (LPG) as the fuel and air as an oxidizer. Temperature distribution as well as combustion gases product i.e. carbon monoxide (CO) and nitrogen oxides (NOx) were measured and analyzed. As for the combustion characteristics, the PMC has shown better temperature distribution compared to free flame combustion (FFC) while about 64% and 59% reduction for CO and NOx emissions, respectively.Keywords
This publication has 16 references indexed in Scilit:
- Preparation of high open porosity ceramic foams via direct foaming molded and dried at room temperatureJournal of the European Ceramic Society, 2014
- The Development and Performance Analysis of Partially Premixed LPG Porous Medium CombustorEnergy Sources, Part A: Recovery, Utilization, and Environmental Effects, 2011
- Fabrication of Porous Silicon Nitride by Sacrificing Template MethodAdvances in Science and Technology, 2010
- Aging of reticulated Si-SiC foams in porous burnersAdvances in Applied Ceramics: Structural, Functional and Bioceramics, 2010
- 3-D NUMERICAL MODELING AND EXPERIMENTAL INVESTIGATION OF A PARTIAL PREMIX-TYPE POROUS MEDIUM BURNER USING LIQUEFIED PETROLEUM GAS FUELJournal of Porous Media, 2010
- Combustion in porous media and its applications – A comprehensive surveyJournal of Environmental Management, 2009
- Facile Synthesis of SiCN Ceramic Foam via Self-Sacrificial Template MethodSolid State Phenomena, 2007
- Manufacture of cordierite foams by direct foamingPolimery, 2007
- Combustion in Porous MediaProceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 2006
- Combustion of hydrocarbon fuels within porous inert mediaProgress in Energy and Combustion Science, 1996