Thermal, mechanical and tribological properties of polycarbonate/acrylonitrile-butadiene-styrene blends
Authors:
- Nay Win KhunNKNay Win Khun
- Erjia LiuErjia Liu
- 1 September 2013
- journal article
- research article
- Published by Walter de Gruyter GmbH in Journal of Polymer Engineering
- Vol. 33 (6) , 535-543
Abstract
Polycarbonate (PC) and acrylonitrile-butadiene-styrene (ABS) were blended by varying ABS content. The thermal, mechanical and tribological properties of the PC/ABS blends were systematically characterized. Increasing ABS content in the PC/ABS blends decreased thermal stability of the blends, as a result of the lower thermal stability of the ABS than that of the PC. Although the tensile strength of the PC/ABS blends apparently decreased with increased ABS content, the PC/ABS blend with 10 wt% of ABS had the highest tensile strength, because of improved processability of the blend. The friction and wear of the ABS measured against a steel ball of 6 mm in diameter were higher than those of the PC. As a result, a higher ABS content in the PC/ABS blends resulted in higher friction and wear of the blends. The scratch results showed that scratching with a 5 mm steel ball generated a scratch with a shorter length and lower depth on the PC than on the ABS, which indicated better scratch resistance of the PC. Therefore, the PC/ABS blend with 50 wt% of PC had better scratch resistance than the ABS, due to the influence of the PC embedded in the blend.Keywords
This publication has 9 references indexed in Scilit:
- Polymers for flexible displays: From material selection to device applicationsProgress in Polymer Science, 2008
- Polycarbonate and co-continuous polycarbonate/ABS blends: influence of notch radiusPolymer, 2002
- Surface topography and wear mechanisms in polyamide 66 and its compositesJournal of Materials Science, 2000
- Effect of the compatibilizers on flame-retardant polycarbonate (PC)/acrylonitrile-butadiene-styrene (ABS) alloyJournal of Applied Polymer Science, 1997
- On the microstructure and tensile strength of PC/ABS polymer blend jointsJournal of Polymer Research, 1995
- Stability of plastic deformation and toughness of polycarbonate blended with poly(acrylonitrile-butadiene-styrene) copolymerPolymer, 1995
- Phase morphology of injection-moulded polycarbonate/acrylonitrile-butadiene-styrene blendsPolymer, 1992
- Thermal behavior, morphology, and some melt properties of blends of polycarbonate with poly(styrene‐co‐acrylonitrile) and poly(acrylonitrile‐butadiene‐styrene)Polymer Engineering & Science, 1988
- Effect of surface roughness on contact between solid surfacesWear, 1974