Compaction influence on spring-in of thin composite parts: Experimental and numerical results
- 4 July 2014
- journal article
- research article
- Published by SAGE Publications in Journal of Composite Materials
- Vol. 49 (17) , 2149-2158
Abstract
Geometric unconformities may arise due to residual stresses during the manufacturing process of polymer matrix composite materials. Compaction of the laminate, due to resin squeeze, is another phenomenon that occurs and it influences the mechanical behaviour of the laminate itself. In the past, models for spring-in or for compaction were developed separately, whereas in the present work a new kind of analysis is developed to take into account both residual stresses and compaction that take place during cure simultaneously. This analysis is composed by two different steps: in the former the compaction is predicted, in the latter the cure state and the residual stress condition are determined. Finally, the relationship between different degrees of compaction and the corresponding values of spring-in is studied, and it was found that a higher value of thickness reduction produces the smallest residual stresses for the composite structures with angled cross sections.Keywords
This publication has 24 references indexed in Scilit:
- Effect of thermal residual stresses on matrix failure under transverse tension at micromechanical level: A numerical and experimental analysisComposites Science and Technology, 2011
- Shear-lag Analysis of the Effect of Thickness on Spring-in of Curved CompositesJournal of Composite Materials, 2007
- An Uneven Strain Model for Analysis of Residual Stress and Interface Stress in Laminate CompositesJournal of Composite Materials, 2002
- Experimental and numerical study of the effect of cure cycle, tool surface, geometry, and lay-up on the dimensional fidelity of autoclave-processed composite partsComposites Part A: Applied Science and Manufacturing, 2002
- Dimensional Accuracy of Thermoset Composites: Shape OptimizationJournal of Composite Materials, 2002
- A Plane Strain Model for Process-Induced Deformation of Laminated Composite StructuresJournal of Composite Materials, 2001
- A consistent cure kinetic model for AS4/3502 graphite/epoxyComposites Part A: Applied Science and Manufacturing, 2000
- Computer simulation of process induced stress and strain development during cure of thick-section thermosetting compositesComputational Materials Science, 1996
- Process-Induced Stress and Deformation in Thick-Section Thermoset Composite LaminatesJournal of Composite Materials, 1992
- Thermal Conductivities of Unidirectional MaterialsJournal of Composite Materials, 1967