The Derivation of the Cross-sectional Area along Wool Fibres from OFDA Diameter Measurements
Authors:
- 1 January 1998
- journal article
- research article
- Published by Taylor & Francis in The Journal of the Textile Institute
- Vol. 89 (1) , 133-141
Abstract
A unique and theoretically sound method of deriving cross-sectional area along wool fibres is developed. Diameter values are derived from an equation based on an ellipse whose parameters are the semi-major and semi-minor axes and the angle of rotation of the ellipse. These parameters are used directly to calculate the cross-sectional area at intervals of approximately 3.2 μm along the length of fibres, to produce a profile at a resolution previously unattained in work reported in the relevant literature. Software-based corrections are necessary to bring pairs of diameter-data series into phase prior to derivation of cross-sectional area and to remove outliers resulting from contamination. A unique three-dimensional representation of a section of wool fibre is created, demonstrating spiralling and dramatic variations in cross-sectional area along relatively short sections of the fibre.Keywords
This publication has 7 references indexed in Scilit:
- Recursive forecasting, smoothing and seasonal adjustment of non‐stationary environmental dataJournal of Forecasting, 1991
- 26—STRUCTURAL AND NON-STRUCTURAL EFFECTS IN THE OBSERVED STRESS-STRAIN CURVE FOR WET WOOL FIBRESThe Journal of the Textile Institute, 1968
- 6—DIMENSIONAL RELATIONS IN UNSTRAINED AND STRAINED WOOL FIBRESJournal of the Textile Institute Transactions, 1966
- The Stress-Strain Behavior of Dimensionally and Structurally Non-Uniform Wool Fibers in WaterTextile Research Journal, 1965
- Morphometry of ‘Doggy’ WoolNature, 1965
- Morphometry of Wool FibresNature, 1963
- WOOL FIBRE CONTOUR: ITS SIGNIFICANCE TO THE MECHANICAL PROPERTIES OF THE FIBREJournal of the Textile Institute Proceedings, 1952