Evolution of local friction along a model pile shaft in a calibration chamber for a large number of loading cycles
Authors:
- Hadj BekkiHBHadj Bekki
- Jean CanouJCJean Canou
- Brahim TaliBTBrahim Tali
- Jean-Claude DuplaJDJean-Claude Dupla
- Ali BouafiaABAli Bouafia
- 7 March 2013
- journal article
- research article
- Published by MathDoc/Centre Mersenne in Comptes Rendus Mécanique
- Vol. 341 (6) , 499-507
Abstract
This Note presents the results of axial loading tests carried out on an instrumented “pile-probe” jacked into sand, in a calibration chamber, aimed at studying the evolution of local friction, up to very large numbers of cycles (105 cycles). After an initial phase of friction degradation (cyclic softening), a subsequent phase of mobilized friction reinforcement (cyclic hardening) is observed, which continues to develop up to very large numbers of cycles. The complete mechanism of shear degradation followed by the reinforcement phase is interpreted based on the competition between two mechanisms which are the mean normal effective stress decrease due to cyclic contractancy phenomenon, responsible for cyclic softening, and the progressive densification of the sand within the interface zone around the probe, which becomes predominant after a certain number of cycles, resulting in a cyclic hardening mechanism due to partially constrained dilatancy phenomenon.Keywords
This publication has 14 references indexed in Scilit:
- Cyclic shear stress degradation and post-cyclic behaviour from sand–steel interface direct shear testsCanadian Geotechnical Journal, 2007
- Lateral stress changes and shaft friction for model displacement piles in sandCanadian Geotechnical Journal, 2005
- Friction fatigue on displacement piles in sandGéotechnique, 2004
- Cyclic Simple-Shear Behavior of Sand-Steel Interfaces under Constant Normal Stiffness ConditionJournal of Geotechnical and Geoenvironmental Engineering, 1997
- Tests on Model Jacked Piles in Calcareous SandGeotechnical Testing Journal, 1996
- Predicted and Observed Cyclic Performance of Piles in Calcareous SandJournal of Geotechnical Engineering, 1995
- Mechanisms of Shaft Friction in Sand from Instrumented Pile TestsJournal of Geotechnical Engineering, 1993
- Pile Capacity for Axial Cyclic Loading by D. V. GriffithsJournal of Geotechnical Engineering, 1992
- Friction Between Sand and Steel Under Repeated LoadingSoils and Foundations, 1989
- Cyclic Soil Data for Design of Gravity StructuresJournal of Geotechnical Engineering, 1988