Frontal vs. bulk polymerization of fiber-reinforced polymer-matrix composites
Authors:
- S. VyasSVS. Vyas
- X. ZhangXZX. Zhang
- E. GoliEGE. Goli
- P.H. GeubellePGP.H. Geubelle
- 1 September 2020
- journal article
- research article
- Published by Elsevier in Composites Science and Technology
- Vol. 198
Abstract
No abstract availableKeywords
Funding Information
- National Science Foundation
- Air Force Office of Scientific Research
This publication has 22 references indexed in Scilit:
- Effect of cure cycle heat transfer rates on the physical and mechanical properties of an epoxy matrix compositeComposites Science and Technology, 2007
- Flow rate control during vacuum-assisted resin transfer molding (VARTM) processingComposites Science and Technology, 2006
- Numerical modeling and experimental study of the frontal polymerization of the diglycidyl ether of bisphenol A/diethylenetriamine epoxy systemJournal of Applied Polymer Science, 2005
- UV‐ignited frontal polymerization of an epoxy resinJournal of Polymer Science Part A: Polymer Chemistry, 2004
- Cure kinetics of the ring‐opening metathesis polymerization of dicyclopentadieneJournal of Polymer Science Part A: Polymer Chemistry, 2002
- Thermoviscoelastic analysis of residual curing stresses and the influence of autoclave pressure on these stresses in carbon/epoxy laminatesComposites Science and Technology, 2002
- Frontal Ring-Opening Metathesis Polymerization of DicyclopentadieneMacromolecules, 2001
- Free-radical frontal polymerization: self-propagating thermal reaction wavesJournal of the Chemical Society, Faraday Transactions, 1996
- Process-Induced Stress and Deformation in Thick-Section Thermoset Composite LaminatesJournal of Composite Materials, 1992
- Autoclave moulding of carbon fibre-reinforced epoxiesComposites, 1986