Tribological Behaviors of W-Doped DLC Films
Authors:
- 1 March 2010
- journal article
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 434-435, 474-476
Abstract
W-doped DLC films were synthesized from CH4 and W by ion beam deposition and magnetron sputtering, and the influence of W target current on the surface morphology and the mechanical properties of W-doped DLC films deposited were studied. The W-doped DLC films in the study have a smooth dense surface with several particles of about 2micron. The hardness, the modulus, and the film-substrate adhesion of the films are increased with the rise of W target current and the critical load of the scratch test for all the W-doped DLC films is above 70N. The friction coefficient of W-doped DLC films is increased with the increase of W target current while the lowest wear rate is obtained when W target current is 1A.Keywords
This publication has 7 references indexed in Scilit:
- Tribological behavior of W-DLC coated rubber sealsSurface and Coatings Technology, 2008
- Differences in the tribological mechanisms when using non-doped, metal-doped (Ti, WC), and non-metal-doped (Si) diamond-like carbon against steel under boundary lubrication, with and without oil additivesThin Solid Films, 2006
- Adhesion studies of diamond-like carbon films deposited on Ti6Al4V substrate with a silicon interlayerThin Solid Films, 2006
- Cr-doped DLC films in three mid-frequency dual-magnetron power modesSurface and Coatings Technology, 2006
- Deposition and microstructure of Ti-containing diamond-like carbon nanocomposite filmsThin Solid Films, 2005
- Hard carbon nanocomposite films with low stressDiamond and Related Materials, 2001
- Applications of diamond-like carbon thin filmsCarbon, 1998