Effect of Electron Beam Surface Modification on the Plasticity of Inconel Alloy 625
Open Access
Abstract
In the present work, we present results on the influence of electron beam surface modification on the resistance to plastic deformation and plasticity of Inconel alloy 625. During the treatment procedure, the electron beam currents were 10 and 20 mA, corresponding to beam powers of 600 W and 1200 W. The structures of the modified specimens were studied using X-ray diffraction (XRD), scanning electron microscopy (SEM), and energy-dispersive X-ray spectroscopy (EDX). The nanohardness and Young’s modulus were studied through nanoindentation experiments. The plasticity of the treated materials as well as of the untreated ones was studied through an evaluation of H3/E2, which points to resistance to plastic deformation. The results obtained show that the electron beam surface modification procedure leads to a reorientation of microvolumes and the formation of a preferred crystallographic orientation. The surface treatment of the samples using an electron beam with a power of 600 W did not lead to major changes in the structures of the samples. However, the use of a beam with a power of 1200 W led to the formation of a clearly separated modified zone with a thickness in the range of 13 to 15 μm. The Young’s modulus increased from about 100 to 153 GPa in the case of electron beam surface modification using the lower-power electron beam. The application of the higher-power electron beam did not lead to a significant change in the modulus of elasticity as compared to the untreated specimen. Also, it was found that the treatment procedure pointed to a decrease in nanohardness when the maximum power of the electron beam was applied. The resistance to plastic deformation, i.e., the H3/E2 ratio, showed that the ratio decreased significantly in both cases of electron beam surface modification, pointing to an improvement in the plasticity of the surface of the Inconel alloy 625.Keywords
Funding Information
- Bulgarian National Science Fund (KP-06-N 67/7)
This publication has 30 references indexed in Scilit:
- A new approach to improve strength and ductility of laser powder deposited Inconel 718 thin-wall structureMaterials Science and Engineering: A, 2022
- Effect of grain refinement and twin structure on the strength and ductility of Inconel 625 alloyMaterials Science and Engineering: A, 2021
- Discrete crystal plasticity modelling of slip-controlled cyclic deformation and short crack growth under low cycle fatigueInternational Journal of Fatigue, 2021
- Improved plasticity of Inconel 718 superalloy fabricated by selective laser melting through a novel heat treatment processMaterials & Design, 2019
- Structure and properties changes of Al-Si alloy treated by pulsed electron beamMaterials Letters, 2018
- Ductility and plasticity of nanostructured metals: differences and issuesMaterials Today Nano, 2018
- Surface hardening of 30CrMnSiA steel using continuous electron beamNuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms, 2017
- Microstructure Characteristics of Inconel 625 Superalloy Manufactured by Selective Laser MeltingJournal of Materials Science & Technology, 2015
- A study of nanoindentation for mechanical characterization of chromium and nickel borides’ mixtures formed by laser boridingCeramics International, 2014
- The relationship between ductility and grain-boundary precipitates in an Al-6.0% Zn-2.6% Mg alloyJournal of Materials Science, 1976