Influence of Pressurisation on SOFC Performance and Durability: A Theoretical Study
- 25 February 2011
- journal article
- research article
- Published by Wiley in Fuel Cells
- Vol. 11 (4) , 581-591
Abstract
Hybrid power plants consisting of a solid oxide fuel cell (SOFC) and a gas turbine show high electrical efficiencies, however require pressurisation of the SOFC to several bar. This paper presents a theoretical investigation of the pressure influence on SOFC performance and durability. A two‐dimensional elementary kinetic model is used to predict the performance of a single cell in the pressure range of 1–20 bar. The influence of pressure on thermodynamics, reaction kinetics, porous electrode diffusion, channel transport and efficiency is assessed. It was found that polarisation resistance decreases with increasing pressure due to increased diffusion through porous electrodes and a higher electrode surface coverage with reactant species. Furthermore, open‐circuit voltage increases slightly with pressure. As a consequence, power density and efficiency increase upon pressurisation with the strongest increase at low pressures between 1 and 5 bar. The influence of pressure on two typical degradation mechanisms, nickel oxidation and carbon deposition, is assessed using thermodynamic simulations. Pressurisation facilitates nickel oxidation whereas its effect on carbon deposition strongly depends on temperature.Keywords
This publication has 35 references indexed in Scilit:
- Fuel cell system modeling for solid oxide fuel cell/gas turbine hybrid power plants, Part I: Modeling and simulation frameworkJournal of Power Sources, 2011
- Modeling of electrochemistry and steam–methane reforming performance for simulating pressurized solid oxide fuel cell stacksJournal of Power Sources, 2010
- Model anodes and anode models for understanding the mechanism of hydrogen oxidation in solid oxide fuel cellsPhysical Chemistry Chemical Physics, 2010
- Modelling Study of Surface Reactions, Diffusion, and Spillover at a Ni/YSZ Patterned AnodeJournal of the Electrochemical Society, 2009
- A new framework for physically based modeling of solid oxide fuel cellsElectrochimica Acta, 2007
- CFD analysis of a solid oxide fuel cell with internal reforming: Coupled interactions of transport, heterogeneous catalysis and electrochemical processesJournal of Power Sources, 2006
- Thermodynamics of SOFC efficiency and fuel utilization as functions of fuel mixtures and operating conditionsJournal of Power Sources, 2006
- Modelling of Pressurised Hybrid Systems Based on Integrated Planar Solid Oxide Fuel Cell (IP‐SOFC) TechnologyFuel Cells, 2005
- Electrochemical Oxidation of CO on Pt and Ni Point Electrodes in Contact with an Yttria-Stabilized Zirconia ElectrolyteJournal of the Electrochemical Society, 2002
- Design and part-load performance of a hybrid system based on a solid oxide fuel cell reactor and a micro gas turbineJournal of Power Sources, 2001