Switching Wave Characteristics Affecting the Life of Type II Machine Turn Insulation
- 4 August 2022
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Dielectrics and Electrical Insulation
- Vol. 29 (5) , 2000-2007
Abstract
In this article, the impact of the waveform switching frequency (SWF), overshoot (OS), and rise time on the time-to-failure and the endurance of Type II machine insulation is investigated. Reference life curves at 1 and 4 kHz SWF are derived utilizing a unipolar repetitive square-impulse of 15% OS and 300 ns rise time. The effects of the impulse OS and rise time in the ranges of 0%–30% and 400–600 ns are also evaluated and reflected on the established reference life curves. Based on the endurance test results and the reported time-to-failure data, it is evident that the turn insulation is subjected to additional stress factors when energized by an inverter supply as opposed to the stresses exhibited by sinusoidal waves. This indicates an incomparable aging rate between the two types of waveforms, even at similar peak voltages applied, resulting in inadequate use of sinusoidal supply to qualify inverter-fed machines. Moreover, the OS component of the waveform is found to have a substantial impact on the endurance of turn insulation apart from the jump voltage impact, and therefore, is identified as a significant factor influencing the life of turn insulation independent of other factors. Moreover, the reported results of the time-to-failure analysis advocate a nonlinear relationship between the SWF and the life of turn insulation, whereas the waveform rise time is found to have a negligible impact within the considered range in this study.Keywords
Funding Information
- Natural Sciences and Engineering Research Council of Canada
This publication has 13 references indexed in Scilit:
- Partial discharge characteristics at ultra-short voltage risetimesIEEE Transactions on Dielectrics and Electrical Insulation, 2018
- Time behavior of partial discharges and life of type II turn insulation specimens under repetitive impulse and sinusoidal waveformsIEEE Electrical Insulation Magazine, 2017
- Experimental investigation of the voltage distribution in form wound windings of large AC machines due to fast transients2016
- Time to failure of medium-voltage form-wound machine turn insulation stressed by unipolar square wavesIEEE Transactions on Dielectrics and Electrical Insulation, 2015
- The influence of impulsive voltage frequency on PD features in turn insulation of inverter-fed motors2014
- Power electronics and electrical insulation systems - part 2: life modeling for insulation designIEEE Electrical Insulation Magazine, 2010
- Investigation of mica based insulation for high voltage machines subjected to repetitive pulsed voltage2010
- High Frequency Life Testing of Stator Coil Insulation2008
- Effects of converter pulses on the electrical insulation in low and medium voltage motorsIEEE Electrical Insulation Magazine, 2005
- Aging acceleration of insulating materials for electrical machine windings supplied by PWM in the presence and in the absence of partial discharges2002