Non-linear control of current-mode buck converter with an optimally scaled auxiliary phase
Authors:
- 1 January 2010
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 783-788
Abstract
The main goal of this work is to de-couple the well-known efficiency/dynamic-response trade-off involved in scaling the inductance in dc-dc converters. This is achieved by introducing a low-cost auxiliary phase having an optimally scaled-down inductor and power-stage. The auxiliary phase is activated by a digital non-linear controller only during large transient events and thus does not affect the efficiency. An experimental 1 MHz, 10 V to 3.3 V current-mode buck converter prototype achieves a settling time below 2 μs and a voltage drop of 50 mV (limited by Rc) for ΔI out =1 A, with an output capacitance of only 10 μF. A robust method was used for detecting the zero crossing of v c (t) and it is shown that if the auxiliary inductor is optimally scaled, charge balancing can easily be achieved for a range of load-steps.Keywords
This publication has 4 references indexed in Scilit:
- Continuous-Time Digital Controller for High-Frequency DC-DC ConvertersIEEE Transactions on Power Electronics, 2008
- A Single Phase Voltage Regulator Module (VRM) With Stepping Inductance for Fast Transient ResponseIEEE Transactions on Power Electronics, 2007
- Transient Response Improvement in DC-DC Converters Using Output Capacitor Current for Faster Transient Detection2007
- An Innovative Digital Control Architecture for Low-Voltage, High-Current DC–DC Converters With Tight Voltage RegulationIEEE Transactions on Power Electronics, 2004