Effect of UV and UV–Ozone Treatment of Polyolefin Fibers on Toughness of Fiber Concrete Composite
Authors:
- 20 March 2013
- journal article
- research article
- Published by ASTM International in Advances in Civil Engineering Materials
- Vol. 2 (1) , 51-61
Abstract
Ultraviolet (UV) irradiation and a combination of UV irradiation and ozone treatment of polyolefin fibers were investigated for possible improvement of mechanical properties in concrete composites. In both treatment methods, various fiber exposure durations were used, and surface modification was monitored by measuring the water contact angle. Untreated and treated fibers were added to concrete at 0.32 % by volume, and the specimens were tested for flexural strength according to ASTM International specifications. Fiber surface treatment by UV alone was found to be an unattractive technique based on the results of flexural tests and contact angle measurements. Ten minutes of UV and ozone surface treatment of fibers was found to improve the composite peak stress by 11 % and the toughness by 4 %; longer periods of exposure led to lower flexural strength results, perhaps as a result of fiber deformation or degradation.Keywords
This publication has 22 references indexed in Scilit:
- Effect of surface treatment on the post-peak residual strength and toughness of polypropylene/polyethylene-blended fiber-reinforced concreteJournal of Composite Materials, 2011
- Surface modification of polyolefine by UV light/ozone treatmentJournal of Applied Polymer Science, 1996
- Surface modification of UHMWPE fibersJournal of Applied Polymer Science, 1994
- Surface Modification of High Performance Polyethylene Fiber by Photo-oxygenation and Its Effect on Mechanical Properties of FRPJournal of the Society of Materials Science, Japan, 1992
- A study of the effects of oxygen plasma treatment on the adhesion behaviour of polyethylene fibresComposites Science and Technology, 1992
- Modification of polymer surfaces by two‐step plasma sensitized reactionsJournal of Polymer Science Part A: Polymer Chemistry, 1990
- Surface modification of polyolefins for hydrophilicity and bondability: Ozonization and grafting hydrophilic monomers on ozonized polyolefinsJournal of Applied Polymer Science, 1990
- Corona‐discharge treatment of polymeric films, II: Chemical studiesPolymer Engineering & Science, 1980
- The mechanism of corona and ultraviolet light‐induced self‐adhesion of poly(ethylene terephthalate) filmJournal of Applied Polymer Science, 1975
- Activated gas plasma surface treatment of polymers for adhesive bondingJournal of Applied Polymer Science, 1969