3D-printed orthoses and prostheses for people with physical disability in rehabilitation centers: a scoping review
Open Access
- 4 October 2024
- journal article
- review article
- Published by Springer Nature in BMC Musculoskeletal Disorders
- Vol. 25 (1) , 1-10
Abstract
The World Health Organization points out that, by 2030, two billion people will need at least one assistive product. 3D printing can be used to meet the demands when dispensing these products. This review aims to map the use of 3D printing in the manufacture of orthoses and prostheses for people with physical disability at rehabilitation centers. Publications that deal with the use of 3D printing for the manufacture of orthoses and prostheses were used, preferably studies from 2012 to 2022. The majority of studies, 56.25%, were quantitative and 46.25% were evaluative research. None of the studies were characterized as developed at rehabilitation centers. 75% of them had the participation of people with physical disability. The use of 3D printing was, for the most part, for the development of assistive technologies for the upper limbs at 56.25%, while 31.25% were for the lower limbs. The assistive products developed were orthoses and prostheses for the wrist, hands, fingers, upper limbs, writing devices, sockets, knees, and feet. Although there were positive results in their performance, some limitations related to strength, stiffness, and resistance were observed.Keywords
This publication has 16 references indexed in Scilit:
- Effects of 3D-printed assistive device on daily life function in patients with neurological impairment: a pilot studyDisability and Rehabilitation: Assistive Technology, 2023
- Key Factors of Design: 3D Printed Occupational Therapy Products in Developing Communities2020
- 3D-printed foot prosthesis during gait: Comparison with two standard prosthesesGait & Posture, 2020
- Manufacturing an assistive device with 3D printing technology – a case reportAssistive Technology, 2020
- Personalized upper limb orthosis necessitates variety of tools during the development process: hemiplegic child case studyDisability and Rehabilitation: Assistive Technology, 2019
- Mechatronic Design and Control of a 3D Printed Low Cost Robotic Upper Limb2018
- Personalized assistive device manufactured by 3D modelling and printing techniquesDisability and Rehabilitation: Assistive Technology, 2018
- Functional changes through the usage of 3D-printed transitional prostheses in childrenDisability and Rehabilitation: Assistive Technology, 2017
- Rehand: Realistic electric prosthetic hand created with a 3D printer2015
- Design of a novel prosthetic socket: Assessment of the thermal performanceJournal of Biomechanics, 2015