Characterization of Particle Packing in an Injected Molded Green Body
Authors:
- 1 November 1995
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 78 (11) , 3107-3109
Abstract
The particle packing structure of alumina green bodies made by injection molding has been examined with the liquid immersion technique coupled with a polarized light microscope. In this method, the specimen is made transparent by an immersion liquid and is examined in the transmission mode. Fine particles of near‐equiaxed alumina powder are found to be aligned, with their slightly elongated axis parallel to the flow direction of the molding process. The presence of very large alumina particles was also noted. Their concentraton was extremely low and can be detected only by the present method. The origins and significance of particle orientaton and large particles in ceramic processing are discussed.Keywords
This publication has 11 references indexed in Scilit:
- Predicting the Incidence of Voids in the Injection Molding of Thick Ceramic SectionsJournal of the American Ceramic Society, 1993
- Liquid Immersion-Polarized Light Microscopy as a Powerful Tool in the Research of Ceramic ProcessingJournal of the Ceramic Society of Japan, 1993
- Measurement of Residual Stres in Injection‐Molded CeramicsJournal of the American Ceramic Society, 1992
- Characterization of internal structure in Y-TZP powder compactsJournal of Materials Science, 1992
- Double-step lamination of grain-oriented Y-Ba-Cu-O superconducting ceramicsJournal of Materials Science, 1992
- Effect of Forming Pressure on the Internal Structure of Alumina Green Bodies Examined with Immersion Liquid TechniqueJournal of the American Ceramic Society, 1991
- Direct Observation of Internal Structure in Spray‐Dried Alumina GranulesJournal of the American Ceramic Society, 1990
- Direct Observation Method for Internal Structure of Ceramic Green BodyJournal of the Ceramic Society of Japan, 1990
- Effect of Powder Characteristics on Compounding and Green Microstructure in the Injection‐Molding ProcessJournal of the American Ceramic Society, 1989
- Effect of Surface Treatment of Al2O3 Fine Particles on Injection MoldingJournal of the Ceramic Society of Japan, 1988