Evaluation of a Ni-20Cr Alloy Processed by Multi-Axis Forging
- 15 January 2006
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 503-504, 793-798
Abstract
This paper discusses the development of a novel processing route to produce ultra finegrain bulk alloy forgings; the microstructural response of these forgings to thermal exposure; and the comparison of mechanical properties to those from conventionally processed material. A Ni- 20Cr [wt%] alloy was processed by near-isothermal multi-axis forging to a grain size of approximately 1 μm. A heat-treatment study over the range 900 to 1200°C was conducted to determine the resultant grain size as a function of time and temperature. Tensile properties were measured at room temperature, 500°C, and 930°C. High-cycle fatigue properties were measured at room temperature. The room-temperature tensile strength was approximately 2.5 times greater than that of conventionally processed Ni-20Cr. Fatigue data showed that the room-temperature highcycle fatigue run-out stress was greater than 100% of the yield stress.Keywords
This publication has 9 references indexed in Scilit:
- The microstructural characteristics of ultrafine-grained nickelMaterials Science and Engineering: A, 2005
- On the homogeneity of deformation by high pressure torsionScripta Materialia, 2004
- Grain Refinement and Microstructural Evolution in Nickel during High‐Pressure Torsion2004
- Thermal stability and microstructural evolution in ultrafine-grained nickel after equal-channel angular pressing (ECAP)Metallurgical and Materials Transactions A, 2002
- The effect of material properties and tooling design on deformation and fracture during equal channel angular extrusionActa Materialia, 2000
- Fabrication and thermal stability of a nanocrystalline Ni–Al–Cr alloy: Comparison with pure Cu and NiJournal of Materials Research, 1999
- Materials processing by simple shearMaterials Science and Engineering: A, 1995
- Diffusion in Solid Metals and Alloys1990
- Mechanical metallurgy.1961