Preparation of open microcellular polylactic acid foams with a microfibrillar additive using coreback foam injection molding processes
Authors:
- 25 April 2018
- journal article
- research article
- Published by SAGE Publications in Journal of Cellular Plastics
- Vol. 54 (4) , 765-784
Abstract
Open microcellular polylactic acid foams with a fibrous polytetrafluoroethylene additive were prepared by a coreback foam injection molding technique. The effects of this fibrous additive on the foam cell structure were investigated. Fibrous polytetrafluoroethylene forms a network structure in polylactic acid in metering and mixing processes. The fibrous polytetrafluoroethylene network increased the viscoelasticity of polylactic acid and provided polylactic acid with a strain-hardening property. The network also provided heterogeneous bubble nucleation sites for physical foaming. However, because of the slow crystallization rate of polylactic acid, the fibrous polytetrafluoroethylene additive did not promote the nucleation of polylactic acid crystals under fast cooling conditions. During fast cooling, such as injection molding cooling conditions, the crystals induced by the fibrous polytetrafluoroethylene network could not behave as bubble nucleation sites. Thus, changes in rheological properties and the increased number of heterogeneous sites contributed to the decrease in cell size, the increase in the number density of cells and the increase in the open cell content. As the number density of cells increased, the cell walls with the fibrous polytetrafluoroethylene fibrous additive became so thin that they could be easily fibrillated by a stretching operation during the coreback operation, while their strain-hardening property prevented the walls from complete breakage. Synergistically conducting cell reduction and stretching (coreback) operations, high expansion ratio foams with high open cell content were prepared. When we adjusted the foaming temperature and holding time, five-fold expansion (i.e. 80% void ratio) foams with cell diameters less than 25 µm and open cell contents (OCC) higher than 80% were produced.Keywords
This publication has 29 references indexed in Scilit:
- Visual observation and numerical studies of N2 vs. CO2 foaming behavior in core‐back foam injection moldingPolymer Engineering & Science, 2011
- Autoclave preparation of expanded polypropylene/poly(lactic acid) blend bead foams with a batch foaming processJournal of Cellular Plastics, 2011
- Effect of Growing Crystalline Phase on Bubble Nucleation in Poly(L-Lactide)/CO2 Batch FoamingIndustrial & Engineering Chemistry Research, 2011
- Rheology and extrusion foaming of chain‐branched poly(lactic acid)Polymer Engineering & Science, 2009
- Study of Thermoplastic PLA Foam ExtrusionJournal of Cellular Plastics, 2008
- Cell morphology analysis of high density polymer foamsPolymer Testing, 2005
- Reactively Modified Poly(lactic acid): Properties and Foam ProcessingMacromolecular Materials and Engineering, 2005
- Visual observation of CO2 foaming of polypropylene‐clay nanocompositesPolymer Engineering & Science, 2004
- Study of injection molded microcellular polyamide‐6 nanocompositesPolymer Engineering & Science, 2004
- Visual Observations of Batch and Continuous Foaming ProcessesJournal of Cellular Plastics, 2003