Ultrafine Grinded and Silane Grafted Iron Ore Tailings as Reinforcing Filler of Styrene Butadiene Rubber
Open Access
Abstract
In order to realize the high value-added resource utilization of solid waste and reduce the cost of rubber manufacturing, iron ore tailings (IOTs) were used as raw material to prepare a reinforcing filler of rubber through ultrafine grinding and surface organic modification techniques. We studied the effects of ball mill grinding conditions on the particle size and distribution of grinded iron ore tailings (G-IOTs). The effects of bis-(triethoxy-silyl-propyl)-tetrasulfide (Si69)-modified G-IOT (Si69-G-IOT) loading levels on the cure characteristics, static mechanical and dynamic mechanical properties of the styrene butadiene rubber (SBR) composites were also explored in this paper. The grinding and modification mechanism of IOTs and the combination of filler and SBR matrix were explored by grinding simulation of population balance model, X-ray diffraction analysis, Fourier transform infrared spectroscopy and scanning electron microscopy. The results showed that when grinding IOTs at 2000 r/min for 150 min, the particle size distribution of the resulting G-IOTs was the narrowest, with a D90 value of 4.42 μm. The tensile strength and elongation at break of SBR filled with 120 phr Si69-G-IOT were 14.97 MPa and 596.36%, respectively.Keywords
Funding Information
- National Key R&D Program of China (2019YFC1904601)
This publication has 50 references indexed in Scilit:
- Silane-grafted silica-covered kaolinite as filler of styrene butadiene rubberApplied Clay Science, 2012
- Particle grinding by high‐intensity ultrasound: Kinetic modeling and identification of breakage mechanismsAIChE Journal, 2010
- Effect of filler size distribution on the mechanical and physical properties of alumina‐filled silicone rubberPolymer Engineering & Science, 2008
- Effect of NaOH and Si69 treatments on the properties of fly ash/natural rubber composites*Polymer Composites, 2005
- Effect of particle size on the properties of Mg(OH)2‐filled rubber compositesJournal of Applied Polymer Science, 2004
- Understanding the Chemistry of the Rubber/Silane Reaction for Silica Reinforcement, Using Model OlefinsRubber Chemistry and Technology, 2003
- The effect of fine mineral admixtures on water requirement of cement pastesCement and Concrete Research, 2000
- Human and environmental contamination in the Iron Quadrangle, BrazilApplied Geochemistry, 2000
- Some solutions for the kinetics of combined fracture and abrasion breakagePowder Technology, 1986
- Introduction to the mathematical description of grinding as a rate processPowder Technology, 1971