Sinusoidal-Excitation-Based Impedance Detection Method to Compensate for Cable Voltage Drop in Remote Power Systems
Open Access
- 20 October 2026
- journal article
- research article
- Published by MDPI AG in Electronics
- Vol. 15 (20) , 4849
Abstract
In remote power supply scenarios, long-distance transmission cables introduce voltage drops due to their inherent impedance, leading to load undervoltage. Additionally, dynamic current variations may cause significant fluctuations in load voltage, potentially exceeding the allowable voltage range. To address these challenges, this paper proposes a sinusoidal-excitation-based impedance detection method, which can achieve source-side single-ended impedance detection of the cable. Based on the detection results, a composite control strategy is developed to compensate for both steady-state and transient voltage drops, effectively mitigating the impact of current variations on load-voltage stability. The operating principle and parameter design are analyzed. Experimental testing is carried out using a hardware prototype with an equivalent R-L test loop, and the verification and comparative results indicate that the proposed method effectively resolves voltage drop and response delay issues caused by long cables, achieving accurate and stable remote voltage regulation.Keywords
Funding Information
- Science and Technology Project of State Grid Anhui Electric Power Co., Ltd. (B3120525001R)
This publication has 22 references indexed in Scilit:
- Data-Efficient Synchronous Machine Winding Short-Circuit Faults Diagnosis Based on Frequency Response Analysis and Active LearningIEEE Sensors Journal, 2025
- Online Monitoring for Underground Power Cable Insulation Based on Resonance Frequency Analysis Under Chirp Signal InjectionIEEE Transactions on Industrial Electronics, 2022
- The Digital–Analog Hybrid Cable Voltage-Drop Compensation Control Strategy Based on a Novel Impedance Detection MethodIEEE Transactions on Industrial Electronics, 2022
- Classification of Faults in Multicore Cable via Time–Frequency Domain ReflectometryIEEE Transactions on Industrial Electronics, 2019
- An Analytical AC Resistance Calculation Method for Multiple-Conductor Feeder Cables in Aircraft Electric Power SystemsIEEE Transactions on Industrial Electronics, 2019
- A Novel Controlled Frequency Band Impedance Measurement Approach for Single-Phase Railway Traction Power SystemIEEE Transactions on Industrial Electronics, 2019
- Wire Mismatch Detection Using a Convolutional Neural Network and Fault Localization Based on Time–Frequency-Domain ReflectometryIEEE Transactions on Industrial Electronics, 2018
- Observer-Based Pulsed Signal Injection for Grid Impedance Estimation in Three-Phase SystemsIEEE Transactions on Industrial Electronics, 2018
- Auto Injection Control for In-Circuit Frequency Response MeasurementIEEE Transactions on Industrial Electronics, 2017
- An ultrasonic guided wave approach for the inspection of overhead transmission line cablesApplied Acoustics, 2017