Role of Powder in the Machining of Al-10%Sicp Metal Matrix Composites by Powder Mixed Electric Discharge Machining
- 27 October 2010
- journal article
- research article
- Published by SAGE Publications in Journal of Composite Materials
- Vol. 45 (2) , 133-151
Abstract
This article reports the results of an experimental study conducted with the objective to understand the mechanism of material removal (role of silicon powder) in powder mixed electric discharge machining (PMEDM) while machining the Al-10%SiCP metal matrix composites. PMEDM is relatively a new development in the direction of enhancement of process capabilities of EDM. A new experimental set-up has been developed in the laboratory for experimentation. This research points out how the suspended powder helps in improving the performance of EDM. Further, the effect of the suspended powder and other selected parameters on process performance (machining rate (MR) and surface roughness (SR)) and subsequent optimal settings of the variables have been obtained using Taguchi method. The obtained experimental results indicate significantly improved performance of PMEDM over EDM. The appropriate addition of silicon powder into the dielectric fluid of EDM increases the MR and decreases the SR. The experimental results further indicate that the powder concentration, peak current, and pulse duration are the significant variables, while the supply voltage is an insignificant variable. The results were verified by conducting confirmation experiments with optimal process conditions.Keywords
This publication has 23 references indexed in Scilit:
- Design of optimisation of cutting parameters for turning metal matrix composites based on the orthogonal arraysJournal of Materials Processing Technology, 2003
- The application of research on powder mixed EDM in rough machiningJournal of Materials Processing Technology, 2002
- Accretion of titanium carbide by electrical discharge machining with powder suspended in working fluidPrecision Engineering, 2001
- Study of added powder in kerosene for the micro-slit machining of titanium alloy using electro-discharge machiningJournal of Materials Processing Technology, 2000
- Near-mirror-finish phenomenon in EDM using powder-mixed dielectricJournal of Materials Processing Technology, 1998
- On the effect of electrodischarge machining parameters on the fatigue life of AISI D6 tool steelJournal of Materials Processing Technology, 1997
- Surface Generation Mechanism in Electrical Discharge Machining with Silicon Powder Mixed FluidInternational Journal of Electrical Machining, 1997
- Powder-suspension dielectric fluid for EDMJournal of Materials Processing Technology, 1995
- A New Process of Finish Machining on Free Surface by EDM MethodsCIRP Annals, 1991
- About the Role of Debris in the Gap During Electrical Discharge MachiningCIRP Annals, 1990