Fatigue Crack Growth Properties of a Cryogenic Structural Steel at Liquid Helium Temperature
Authors:
- 1 January 1996
- journal article
- Published by ASME International in Journal of Engineering Materials and Technology
- Vol. 118 (1) , 109-113
Abstract
The structural materials of the coils of superconducting magnets utilized in thermonuclear fusion reactors are used at liquid helium (4.2 K) temperatures and are subjected to repeated thermal stresses and electromagnetic forces. A high strength, high toughness austenitic stainless steel (12Cr-12Ni-10Mn-5Mo-0.2N) has recently been developed for large, thick-walled components used in such environments. This material is non-magnetic even when subjected to processing and, because it is a forging material, it is advantageous as a structural material for large components. In the current research, a large forging of 12Cr-12Ni-10Mn-5Mo-0.2N austenitic stainless steel, was fabricated to a thickness of 250 mm, which is typical of section thicknesses encountered in actual equipment. The tensile fatigue crack growth properties of the forging were examined at liquid helium temperature as function of specimen location across the thickness of the forging. There was virtually no evidence of variation in tensile strength or fatigue crack growth properties attributable to different sampling locations in the thickness direction and no effect of thickness due to the forging or solution treatment associated with large forgings was observed. It has been clarified that there are cases in which small scale yielding (SSY) conditions are not fulfilled when stress ratios are large. ΔJ was introduced in order to achieve unified expression inclusive of these regions and, by expressing crack growth rate accordingly, the following formula was obtained at the second stage (middle range). da/dN = CJ ΔJmJ, CJ = AJ/(ΔJ0)mJ, where, AJ = 1.47 × 10−5 mm/cycle, ΔJ0 = 2.42 × 103N/m.Keywords
This publication has 12 references indexed in Scilit:
- Near-Threshold Crack Propagation Behaviour at Low Temperatures.TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A, 1993
- Near-threshold Fatigue Crack Growth of 316L Stainless Steel at Liquid Helium TemperatureJournal of the Society of Materials Science, Japan, 1989
- Fatigue Crack Growth Rate of Structural Materials for Cryogenic UseJournal of the Society of Materials Science, Japan, 1989
- Review and extension of compliance information for common crack growth specimensInternational Journal of Fracture, 1978
- Fatigue Crack Growth Resistance of Structural Alloys at Cryogenic Temperatures1978
- Fatigue Crack Growth Rates of Structural Alloys at 4 K1977
- Geometry Effects and the J-Integral Approach to Elastic-Plastic Fatigue Crack Growth1976
- Fatigue crack propagation in 4140 steelMetallurgical Transactions A, 1975
- Kinetic theory approach to fatigue crack propagation in terms of dislocation dynamicsInternational Journal of Fracture, 1974
- A Critical Analysis of Crack Propagation LawsJournal of Basic Engineering, 1963