Modelling and characterisation of roughness of moulds produced by high-speed machining with ball-nose end mill
- 8 August 2016
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture
- Vol. 231 (6) , 933-944
Abstract
Cusps and scallops of hardened steel moulds produced by high-speed milling using a ball-nose end mill were mathematically modelled, characterised by microscopy and experimentally validated. The experimental results show that the part material is crushed or ploughed near the cutter centre, where the cutting speed is very low. This kinematic singularity, associated with tool feed, compresses and bends the ball-nose end mill axially. Because of this double effect, the end mill marks on the part at the end of the milling path cause surface damage and dimensional errors to the hardened mould. A mathematical model may predict the formation of the cusps and scallops and be of use in computer numerical control or computer-aided manufacturing programming to obtain the desired part topography.Keywords
This publication has 24 references indexed in Scilit:
- A knowledge base model for complex forging die machiningComputers & Industrial Engineering, 2011
- Surface roughness prediction in milling based on tool displacementsJournal of Manufacturing Processes, 2011
- Investigation of cutting force behaviour considering the effect of cutting edge radius in the micro-scale milling of AISI 1045 steelProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2010
- Investigations of tool edge radius effect in micromachining: A FEM simulation approachJournal of Materials Processing Technology, 2008
- The influence of cutter orientation and workpiece angle on machinability when high-speed milling Inconel 718 under finishing conditionsInternational Journal of Machine Tools and Manufacture, 2007
- FREE-FORM SURFACE MACHINING AND COMPARING FEEDRATE SCHEDULING STRATEGIESMachining Science and Technology, 2007
- Toolpath selection based on the minimum deflection cutting forces in the programming of complex surfaces millingInternational Journal of Machine Tools and Manufacture, 2007
- The statistical modeling of surface roughness in high-speed flat end millingInternational Journal of Machine Tools and Manufacture, 2006
- The effect of machined topography and integrity on fatigue lifeInternational Journal of Machine Tools and Manufacture, 2004
- Effect of cutter mark on surface roughness and scallop height in sculptured surface machiningComputer-Aided Design, 1994