Determining the side force appearance and its magnitude over a slender body at high angle of attack
Authors:
- 1 November 2021
- journal article
- research article
- Published by Pleiades Publishing Ltd in Thermophysics and Aeromechanics
- Vol. 28 (6) , 919-930
Abstract
One of the challenges, especially at low speeds, is the behavior of flow at high angles of attack, which usually leads to asymmetric separation of flows around slender bodies and increased side force. In this paper, a cylindrical cone is examined numerically. For this study, an asymmetric grid is used to capture this expected phenomenon. According to the results, the phenomenon of asymmetry does not occur until the angle of 20 degrees, and as the angle of attack increases, the asymmetry and consequently, the side force increases. At angles close to 90 degrees, the side force decreases significantly. Also, increasing the speed (increasing the Reynolds number and Mach number) reduces the effect of this phenomenon. A way to reduce the effect of this phenomenon is to change the geometry of the nose in a way that reduces its sensitivity to these instabilities and reduces side force. A blowing can also be used to control this phenomenon. Results show that bluntness and a parabolic nose prevents this phenomenon to some extent. A parabolic nose can reduce side force by about 40 %. By removing the sharp tip of the conical nose and adding blowing on blunt tip, the side force is reduced up to 37 % and 43 %, respectively.Keywords
This publication has 29 references indexed in Scilit:
- Low-frequency unsteadiness of vortex wakes over slender bodies at high angle of attackChinese Journal of Aeronautics, 2014
- The drag reduction in spherical spiked blunt bodyActa Astronautica, 2014
- Computational analysis of flow fields around flanged diffusersJournal of Wind Engineering and Industrial Aerodynamics, 2014
- Asymmetric Vortices around a Body at High Angle of Attack Supersonic FlowJournal of the Korean Physical Society, 2009
- Aerodynamic characteristics and parameters of the cone base region at transonic speedsThermophysics and Aeromechanics, 2008
- Stability of Vortex Pairs over Slender Conical Bodies: Analysis and Numerical ComputationAIAA Journal, 2008
- Asymmetric Vortices on a Slender Body of RevolutionAIAA Journal, 1991
- Effect of roughness on rollup of tip vortices on a rectangular hydrofoilJournal of Aircraft, 1989
- Pressures Around an Inclined Ogive Cylinder with Laminar, Transitional, or Turbulent SeparationAIAA Journal, 1982
- Active Control of Asymmetric Vortex EffectsJournal of Aircraft, 1981