Flow Patterns and Heat Transfer for Flow Boiling in Small to Micro Diameter Tubes
Authors:
- 1 April 2010
- journal article
- research article
- Published by Taylor & Francis in Heat Transfer Engineering
- Vol. 31 (4) , 257-275
Abstract
An overview of the recent developments in the study of flow patterns and boiling heat transfer in small to micro diameter tubes is presented. The latest results of a long-term study of flow boiling of R134a in five vertical stainless-steel tubes of internal diameter 4.26, 2.88, 2.01, 1.1, and 0.52 mm are then discussed. During these experiments, the mass flux was varied from 100 to 700 kg/m2s and the heat flux from as low as 1.6 to 135 kW/m2. Five different pressures were studied, namely, 6, 8, 10, 12, and 14 bar. The flow regimes were observed at a glass section located directly at the exit of the heated test section. The range of diameters was chosen to investigate thresholds for macro, small, or micro tube characteristics. The heat transfer coefficients in tubes ranging from 4.26 mm down to 1.1 mm increased with heat flux and system pressure, but did not change with vapor quality for low quality values. At higher quality, the heat transfer coefficients decreased with increasing quality, indicating local transient dry-out, instead of increasing as expected in macro tubes. There was no significant difference between the characteristics and magnitude of the heat transfer coefficients in the 4.26 mm and 2.88 mm tubes but the coefficients in the 2.01 and 1.1 mm tubes were higher. Confined bubble flow was first observed in the 2.01 mm tube, which suggests that this size might be considered as a critical diameter to distinguish small from macro tubes. Further differences have now been observed in the 0.52 mm tube: A transitional wavy flow appeared over a significant range of quality/heat flux and dispersed flow was not observed. The heat transfer characteristics were also different from those in the larger tubes. The data fell into two groups that exhibited different influences of heat flux below and above a heat flux threshold. These differences, in both flow patterns and heat transfer, indicate a possible second change from small to micro behavior at diameters less than 1 mm for R134a.Keywords
This publication has 49 references indexed in Scilit:
- Examination of heat transfer correlations and a model for flow boiling of R134a in small diameter tubesInternational Journal of Heat and Mass Transfer, 2007
- Confined growth of a vapour bubble in a capillary tube at initially uniform superheat: Experiments and modellingInternational Journal of Heat and Mass Transfer, 2006
- Experimental study of evaporation heat transfer characteristics of refrigerants R-134a and R-407C in horizontal small tubesInternational Journal of Heat and Mass Transfer, 2006
- Effect of tube diameter on boiling heat transfer of R-134a in horizontal small-diameter tubesInternational Journal of Heat and Mass Transfer, 2005
- Phase change phenomena in silicon microchannelsInternational Journal of Heat and Mass Transfer, 2005
- Flow boiling heat transfer in two-phase micro-channel heat sinks––I. Experimental investigation and assessment of correlation methodsInternational Journal of Heat and Mass Transfer, 2003
- Flow boiling heat transfer of Freon R11 and HCFC123 in narrow passagesInternational Journal of Heat and Mass Transfer, 2000
- Boiling nucleation during liquid flow in microchannelsInternational Journal of Heat and Mass Transfer, 1998
- Forced convection and flow boiling heat transfer for liquid flowing through microchannelsInternational Journal of Heat and Mass Transfer, 1993
- Saturated flow boiling of water in vertical tubesInternational Journal of Heat and Mass Transfer, 1989