Analysis and Design of an Interleaved Active-Clamping Forward Converter
Authors:
- Yu-Kang LoYLYu-Kang Lo
- Tsu-Shou KaoTKTsu-Shou Kao
- Jing-Yuan LinJLJing-Yuan Lin
- 30 July 2007
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 54 (4) , 2323-2332
Abstract
This paper presents a new interleaved active- clamping zero-voltage-switching (ZVS) forward converter, which is mainly composed of two active-clamping forward converters. Only two switches are required, and each one is the auxiliary switch for the other. The circuit complexity and cost are thus reduced. The leakage inductance of the transformer or an additional resonant inductance is employed to achieve ZVS during the dead times. The duty cycles are not limited to be equal and within 50%. The complementary switchings and the resulted interleaved output inductor currents diminish the current ripple in output capacitors. Accordingly, the smaller output chokes and capacitors lower the converter volume and increase the power density. Detailed analysis and design of this new interleaved active-clamping forward converter are described. Experimental results are recorded for a prototype converter with an ac input voltage of 85-135 Vrms, an output voltage of 12 V, and an output current of 16 A, which operates at a switching frequency of 150 kHz.Keywords
This publication has 16 references indexed in Scilit:
- High-Efficiency Active-Clamp Forward Converter With Transient Current Build-Up (TCB) ZVS TechniqueIEEE Transactions on Industrial Electronics, 2007
- Analysis, design, and implementation of an active clamp forward converter with synchronous rectifierIEEE Transactions on Circuits and Systems I: Regular Papers, 2006
- Design consideration of the active-clamp forward converter with current mode control during large-signal transientIEEE Transactions on Power Electronics, 2003
- A forward converter topology employing a resonant auxiliary circuit to achieve soft switching and power transformer resettingIEEE Transactions on Industrial Electronics, 2003
- Active clamped ZVS forward converter with soft-switched synchronous rectifier for maximum efficiency operation2002
- Large-signal transient analysis of forward converter with active-clamp resetIEEE Transactions on Power Electronics, 2002
- A new snubber circuit for high efficiency and overvoltage limitation in three-level GTO invertersIEEE Transactions on Industrial Electronics, 1997
- Utilization of an active-clamp circuit to achieve soft switching in flyback convertersIEEE Transactions on Power Electronics, 1996
- Design and evaluation of two types of controllers for a two-switch forward converter with extended duty cycle capabilityIEEE Transactions on Industrial Electronics, 1992
- A unified approach to characterization of PWM and quasi-PWM switching converters: topological constraints, classification, and synthesisIEEE Transactions on Power Electronics, 1991