Effect of Recycling on the Cellular Structure of Polylactide in a Batch Process
Open Access
- 1 March 2018
- journal article
- research article
- Published by SAGE Publications in Cellular Polymers
- Vol. 37 (2) , 69-79
Abstract
The aim of the work is to demonstrate the possibility of using recycled biodegradable material as a cellular material with a reduced weight. An experimental study on the influence of recycling on the properties and foam ability of polylactide (PLA) was carried out. The influence of recycling on the polymer crystallinity, thermal and viscoelastic properties was investigated. During the batch process the cellular structure in PLA and recycled PLA were created. A higher degree of crystallinity, a lower viscosity value and a lower melt strength for recycled PLA, as compared to original material, were observed. For the recycled PLA, a fine cellular structure and low density (0.60 g/cm3) were obtained.Keywords
This publication has 27 references indexed in Scilit:
- Multifunctionality of foamed poly(lactid acid) and its composites with nanofillersPolymer Composites, 2014
- Physical extruder foaming of poly(lactic acid)—processing and foam propertiesPolymer Engineering & Science, 2012
- Porous poly(lactic acid) and PLA‐nanocomposite structuresJournal of Applied Polymer Science, 2011
- Microcellular extrusion‐foaming of polylactide with chain‐extenderPolymer Engineering & Science, 2009
- The effect of morphology and chemical characteristics of cellulose reinforcements on the crystallinity of polylactic acidJournal of Applied Polymer Science, 2006
- Open‐celled microcellular thermoplastic foamPolymer Engineering & Science, 2001
- Effect of the crystallinity and morphology on the microcellular foam structure of semicrystalline polymersPolymer Engineering & Science, 1996
- A microcellular processing study of poly(ethylene terephthalate) in the amorphous and semicrystalline states. Part I: Microcell nucleationPolymer Engineering & Science, 1996
- A microcellular processing study of poly(ethylene terephthalate) in the amorphous and semicrystalline states. Part II: Cell growth and process designPolymer Engineering & Science, 1996
- Filamentary extrusion of microcellular polymers using a rapid decompressive elementPolymer Engineering & Science, 1996