Experimental Study on Gas–Solid Two-Phase Flow Characteristics of a Vertical Cyclone Combustor System
Open Access
- 30 November 2023
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 8 (49) , 46914-46921
Abstract
According to the design and operational parameters of the cyclone liquid slag-discharging boiler, an experimental platform for the cyclone burner was designed and constructed in a cold state based on the principle of similarity. The experimental study investigated the effects of parameters, such as swirl-vane angles, coal concentration, operating parameters, and particle size, on the flow distribution and vertical riser resistance characteristics of the vertical cyclone burner. The results showed that there were differences in flow distribution among the cyclone burners, and the most uniform flow distribution was achieved when the swirl-vane angle of the primary air was 30(degrees). The concentration of pulverized coal significantly influenced the pressure drop in the vertical ascending section, which increased with higher concentrations of pulverized coal. When the concentration of pulverized coal remains constant, the pipeline pressure drop is minimized at a primary air velocity of 7.5 m/s. As the secondary wind speed increased, the pressure drop consistently rose; when the secondary wind speed is 22 m/s, the pressure drop of the pipeline is the maximum; however, excessively high secondary wind speeds were found to be detrimental to the formation of an optimal aerodynamic field in the burner. Furthermore, when the pulverized coal concentration was held constant, materials with larger particle sizes exhibited the highest pressure drop. When the particle size increases from 50 to 150 mu m, the pressure drop of the vertical riser segment also increases. Finally, based on the Barth additional pressure drop theory, the pressure drop formula of the vertical riser is fitted by a dimensional analysis method, and the correlation formula of the pressure drop test of gas-solid two-phase flow in the vertical riser is obtained.Keywords
Funding Information
- National Key Research and Development Program of China (2018YFB0604103)
- Ministry of Science and Technology of the People's Republic of China (G2023026002L)
- Henan Province (224200510022, 232102320206)
This publication has 28 references indexed in Scilit:
- Determination of a particle size distribution criterion for predicting dense phase pneumatic conveying behaviour of granular and powder materialsPowder Technology, 2016
- Numerical prediction of erosion distributions and solid particle trajectories in elbows for gas–solid flowJournal of Natural Gas Science and Engineering, 2016
- CFD–DEM simulation of the pneumatic conveying of fine particles through a horizontal slitParticuology, 2014
- Two-fluid modeling of turbulent particle–gas suspensions in vertical pipesPowder Technology, 2014
- Farmland damage and its impact on the overlapped areas of cropland and coal resources in the eastern plains of ChinaResources, Conservation and Recycling, 2014
- Numerical study of horizontal pneumatic conveying: Effect of material propertiesPowder Technology, 2014
- Numerical Simulation for Hydrodynamic Analysis and Pressure Drop Prediction in Horizontal Gas-Solid FlowsParticulate Science and Technology, 2013
- Effect of mechanical properties of powder on pneumatic conveying in inclined pipePowder Technology, 2002
- Dense phase conveying of fine coal at high total pressuresPowder Technology, 1990
- Strömungsvorgänge beim Transport von Festteilchen und Flüssigkeitsteilchen in Gasen. mit besonderer Berücksichtigung der Vorgänge bei pneumatischer FörderungChemie Ingenieur Technik, 1958