Influence of Alloys Position, Rolling and Welding Directions on Properties of AA2024/AA7050 Dissimilar Butt Weld Obtained by Friction Stir Welding
Open Access
Abstract
Friction stir welding (FSW) was carried out for the butt joining of dissimilar AA2024-T3 and AA7050-T7651 aluminium alloys with 2-mm thicknesses. A comparison between the position and orientation of different materials was performed by varying the welding speed while keeping the rotational speed constant. Through an analysis of the force and torque produced during welding and a simple analytical model, the results indicate that the heat input was reduced when the AA7050 alloy was located in the advancing side (AS) of the joint. The different material positions influenced the material transportation and the interface in the centre of the stir zone (SZ). The microhardness of both materials was lower when they were in the AS of the joint. The differences in the hardness values were reduced at higher welding speeds when the heat input was decreased. The mechanical performance increased when the lower strength alloy was located in the AS. The material orientation exhibited a small influence when the AA7050 alloy was in the AS and in general on the resulting microhardness for all the cases analysed. The tensile strength values were very similar for both orientations, but an increase in the yield strength could be measured when the materials were oriented in the transverse direction.Keywords
This publication has 22 references indexed in Scilit:
- Influence of a non-rotating shoulder on heat generation, microstructure and mechanical properties of dissimilar AA2024/AA7050 FSW jointsJournal of Materials Science & Technology, 2018
- Microstructural Characteristics and Mechanical Properties of 7050-T7451 Aluminum Alloy Friction Stir-Welded JointsJournal of Materials Engineering and Performance, 2016
- Friction stir welding of dissimilar materials between AA6061 and AA7075 Al alloys effects of process parametersMaterials & Design (1980-2015), 2014
- Material flow and mechanical behaviour of dissimilar AA2024-T3 and AA7075-T6 aluminium alloys friction stir weldsMaterials & Design (1980-2015), 2011
- Evolution of microstructure and mechanical properties in naturally aged 7050 and 7075 Al friction stir weldsMaterials Science and Engineering: A, 2010
- Preliminary study on the microstructure and mechanical properties of dissimilar friction stir welds in aircraft aluminium alloys 2024-T351 and 6056-T4Journal of Materials Processing Technology, 2008
- Recent advances in friction-stir welding – Process, weldment structure and propertiesProgress in Materials Science, 2008
- Friction stir welding of dissimilar AA2024 and AA7075 aluminum alloysMaterials Science and Engineering: B, 2008
- Friction stir welding and processingMaterials Science and Engineering: R: Reports, 2005
- Microstructural investigation of friction stir welded 7050-T651 aluminiumActa Materialia, 2003