Instrumentation circuitry for an inductive wear debris sensor
Authors:
- 1 June 2012
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 501-504
Abstract
The design of instrumentation circuitry for an inductive sensor to detect small metal particles is presented. The sensor, designed for counting and characterizing wear debris particles in lubrication oil, detects changes in the inductance of a small coil as metal particles pass through it. A change in inductance produces a differential voltage at the output of a Maxwell-Wien bridge, which is then amplified and rectified to produce a DC voltage pulse detectable using standard data acquisition components. For iron particles approximately 75μm and 150μm in diameter, the circuit produces output voltage pulses of 381mV and 693mV, respectively.Keywords
This publication has 7 references indexed in Scilit:
- A high throughput inductive pulse sensor for online oil debris monitoringTribology International, 2011
- Detection of precursor wear debris in lubrication systems2002
- Voltage-mode and current-mode Sallen-Key implementations based on translinear conveyorsIEE Proceedings G Circuits, Devices and Systems, 1992
- An inductive method for estimating the composition and size of metal particlesMeasurement Science and Technology, 1990
- A novel industrial application for magnetoresistive sensors (machine testing)Journal of Physics E: Scientific Instruments, 1985
- Use of a capacitively coupled marginal oscillator for contactless transient conductivity measurementsReview of Scientific Instruments, 1980
- Calibration of inductance standards in the Maxwell-Wien bridge circuitJournal of Research of the National Bureau of Standards, Section C: Engineering and Instrumentation, 1961