Multiscale mechanical characterization of 3D-printed PLA composites with carbon fiber reinforcement: effect of raster angle and layer thickness
Authors:
- 27 March 2025
- journal article
- research article
- Published by Springer Nature in The International Journal of Advanced Manufacturing Technology
- Vol. 137 (9-10) , 4805-4824
Abstract
No abstract availableKeywords
This publication has 28 references indexed in Scilit:
- Effect of moisture content on the mechanical performance of 3D printed continuous reinforced two-matrix compositeThe International Journal of Advanced Manufacturing Technology, 2024
- In situ experimental characterization and numerical investigation of Fe-TiB2 Steel Matrix Composite behavior considering fully coupled damage model: Simulation during incremental forming processMaterials Today Communications, 2023
- Effects of raster angle on the mechanical properties of PLA and Al/PLA composite part produced by fused deposition modelingPolymers for Advanced Technologies, 2019
- Experimental characterization and micrography of 3D printed PLA and PLA reinforced with short carbon fibersComposites Part B: Engineering, 2017
- Additive manufacturing in unmanned aerial vehicles (UAVs): Challenges and potentialAerospace Science and Technology, 2017
- Multifunctional metal matrix composites with embedded printed electrical materials fabricated by ultrasonic additive manufacturingComposites Part B: Engineering, 2017
- Surface roughness effects on the reinforcement of cement mortars through 3D printed metallic fibersComposites Part B: Engineering, 2016
- Low-cycle fatigue behavior of 3d-printed PLA-based porous scaffoldsComposites Part B: Engineering, 2016
- Additive Manufacturing Offers New Opportunities in UAV ResearchProcedia CIRP, 2016
- Powering up on powder technologyMetal Powder Report, 2015