Role of growth temperature on microstructural and electronic properties of rapid thermally grown MoTe2 thin film for infrared detection
- 1 October 2024
- journal article
- research article
- Published by IOP Publishing in Nanotechnology
- Vol. 35 (50) , 505704
Abstract
In the field of electronic and optoelectronic applications, two-dimensional materials are found to be promising candidates for futuristic devices. For the detection of infrared (IR) light, MoTe2 possesses an appropriate bandgap for which p-MoTe2/n-Si heterojunctions are well suited for photodetectors. In this study, a rapid thermal technique is used to grow MoTe2 thin films on silicon (Si) substrates. Molybdenum (Mo) thin films are deposited using a sputtering system on the Si substrate and tellurium (Te) film is deposited on the Mo film by a thermal evaporation technique. The substrates with Mo/Te thin films are kept in a face-to-face manner inside the rapid thermal-processing furnace. The growth is carried out at a base pressure of 2 torr with a flow of 160 sccm of argon gas at different temperatures ranging from 400 °C to 700 °C. The x-ray diffraction peaks appear around 2θ = 12.8°, 25.5°, 39.2°, and 53.2° corresponding to (002), (004), (006), and (008) orientation of a hexagonal 2H-MoTe2 structure. The characteristic Raman peaks of MoTe2, observed at ∼119 cm−1 and ∼172 cm−1, correspond to the in-plane E1g and out-of-plane A1g modes of MoTe2, whereas the prominent peaks of the in-plane E1 2g mode at ∼234 cm−1 and the out-of-plane B1 2g mode at ∼289 cm−1 are also observed. Root mean square (RMS) roughness is found to increase with increasing growth temperature. The bandgap of MoTe2 is calculated using a Tauc plot and is found to be 0.90 eV. Electrical characterizations are carried out using current–voltage and current–time measurement, where the maximum responsivity and detectivity are found to be 127.37 mA W−1 and 85.21 × 107 Jones for a growth temperature of 600 °C and an IR wavelength illumination of 1060 nm.Keywords
This publication has 60 references indexed in Scilit:
- Suppression of Oxide and Interface Charge Density in Radio Frequency Sputtered Ta2O5 Thin FilmsPhysica Status Solidi (a), 2023
- Effect of annealing temperature on SnS thin films for photodetector applicationsJournal of Materials Science: Materials in Electronics, 2022
- A New Strategy for Selective Area Growth of Highly Uniform InGaAs/InP Multiple Quantum Well Nanowire Arrays for Optoelectronic Device ApplicationsAdvanced Functional Materials, 2021
- Gate‐Tunable Photodiodes Based on Mixed‐Dimensional Te/MoTe2 Van der Waals HeterojunctionsAdvanced Electronic Materials, 2021
- 2D Metal Chalcogenides for IR PhotodetectionSmall, 2019
- Photoelectric Detectors Based on Inorganic p‐Type Semiconductor MaterialsAdvanced Materials, 2018
- Anisotropic Broadband Photoresponse of Layered Type‐II Weyl Semimetal MoTe2Advanced Materials, 2018
- Nanostructured Materials and Architectures for Advanced Infrared PhotodetectionAdvanced Materials Technologies, 2017
- Near-Infrared Photodetectors Based on MoTe2 /Graphene Heterostructure with High Responsivity and FlexibilitySmall, 2017
- In‐Plane 2H‐1T′ MoTe2 Homojunctions Synthesized by Flux‐Controlled Phase EngineeringAdvanced Materials, 2017