Effect of laser parameters on microstructure, metallurgical defects and property of AlSi10Mg printed by selective laser melting
Authors:
- 1 December 2017
- journal article
- research article
- Published by World Scientific Pub Co Pte Ltd in Journal of Micromechanics and Molecular Physics
- Vol. 02 (04)
Abstract
AlSi10Mg alloy has been widely used in selective laser melting (SLM). However, the formation of metallurgical defects in this material during SLM process has not been studied sufficiently. In this work, different laser parameters were adopted to fabricate the specimens. The effects of volumetric energy density (VED) on the metallurgical defect, densification, phase composition and mechanical property were also comprehensively analyzed. At low VED of 37.39[ ]J/mm3, a nearly full dense sample with density of 2.602[ ]g/cm3 can be printed. The sample with maximal tensile strength of 475[ ]MPa can be printed. While with the increase of VED, the ultimate tensile strength decreases due to the formation of micro-pores. The formation mechanisms of micro-pores including gas pores and keyhole-induced pores were disclosed from the angle of alloy smelting. Better understanding of the influence mechanisms of the laser parameters on the formation of metallurgical defects is beneficial for the production of high performance SLM parts.Keywords
This publication has 15 references indexed in Scilit:
- Direct current-enhanced densification kinetics during spark plasma sintering of tungsten powderScripta Materialia, 2018
- Selective laser melting of a novel Sc and Zr modified Al-6.2 Mg alloy: Processing, microstructure, and propertiesPowder Technology, 2017
- Microstructures and mechanical properties of A356 (AlSi7Mg0.3) aluminum alloy fabricated by selective laser meltingMaterials & Design, 2016
- Enhanced atomic diffusion of Fe–Al diffusion couple during spark plasma sinteringScripta Materialia, 2016
- Densification behavior, microstructure evolution, and wear property of TiC nanoparticle reinforced AlSi10Mg bulk-form nanocomposites prepared by selective laser meltingJournal of Laser Applications, 2014
- Selective Laser Melting Additive Manufacturing of Ti-Based Nanocomposites: The Role of NanopowderMetallurgical and Materials Transactions A, 2013
- Balling behavior of stainless steel and nickel powder during selective laser melting processThe International Journal of Advanced Manufacturing Technology, 2011
- Densification behavior of gas and water atomized 316L stainless steel powder during selective laser meltingApplied Surface Science, 2010
- Influence of melt superheat on breakup process of close-coupled gas atomizationTransactions of Nonferrous Metals Society of China, 2007
- Satellite formation mechanism in gas atomised powdersPowder Metallurgy, 1999