Visualization and Modeling of Pilot Injection and Combustion in Diesel Engines
Authors:
- 1 February 1996
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
An endoscope-based image acquisition-and-processing camera system was used for diagnostics of pilot injection combustion in a single-cylinder heavy duty diesel engine. A study of the pilot injection or light load is of interest because the spray breakup, mixing and vaporization processes are less influenced by heat feedback from the flame than in full injection cases. This allows the spray process to be decoupled from the combustion process. The experimental cases were modeled using a version of the KIVA-II code that includes improvements in the turbulence, wall heat transfer, spray, ignition and combustion models. Pilot injections of three different amounts (10, 15 and 20% of the fuel injected at 75% load and 1600 RPM) at different start-of-injection timings were studied. The imaging system included an endoscope, an intensified CID camera, a frame grabber and the control circuitry. The combustion of the pilot injections was characterized by ignition sites located below the point where the spray impinges on the piston bowl surface for the injector configuration used in this study. Multiple ignition sites were observed and the majority of the combustion occurred at the, bottom of the piston bowl, spreading along the bowl edge. As the start-of-injection timing was retarded some evidence of ignition above the impingement point was observed. However, these ignition sites did not develop into major combustion zones. Comparisons of the experimental results, which included pressure traces, heat release rates and the luminous flame images, and the numerical computations were made to assess the performance of current models in the KIVA-II code. Good agreement was obtained for the timing and location of ignition. The penetration of the flame observed in the luminous flame images was also captured in the predictions. A feature of the pilot injection that was not captured by the prediction is the spread of the flame along the edge of the piston bowl. The comparisons indicate that recent improvements in KIVA-II allow better prediction of the combustion of pilot injections.Keywords
This publication has 12 references indexed in Scilit:
- MODELING FUEL SPRAY IMPINGEMENT AND HEAT TRANSFER BETWEEN SPRAY AND WALL IN DIRECT INJECTION DIESEL ENGINESNumerical Heat Transfer, Part A: Applications, 1995
- The Effect of TDC Temperature and Density on the Liquid-Phase Fuel Penetration in a D. I. Diesel Engine *SAE International Journal of Advances and Current Practices in Mobility, 1995
- The Development and Application of a Diesel Ignition and Combustion Model for Multidimensional Engine SimulationSAE International Journal of Advances and Current Practices in Mobility, 1995
- Ignition and Early Soot Formation in a DI Diesel Engine Using Multiple 2-D Imaging Diagnostics *SAE International Journal of Advances and Current Practices in Mobility, 1995
- In-Cylinder Diesel Flame Imaging Compared with Numerical ComputationsSAE International Journal of Advances and Current Practices in Mobility, 1995
- MODELING HEAT TRANSFER TO IMPINGING FUEL SPRAYS IN DIRECT-INJECTION ENGINESAtomization and Sprays, 1995
- Turbulence Modeling of Internal Combustion Engines Using RNG κ-ε ModelsCombustion Science and Technology, 1995
- Modeling the Effects of Fuel Injection Characteristics on Diesel Engine Soot and NOx EmissionsSAE International Journal of Advances and Current Practices in Mobility, 1994
- Diesel Engine Combustion Studies in a Newly Designed Optical-Access Engine Using High-Speed Visualization and 2-D Laser ImagingSAE International Journal of Advances and Current Practices in Mobility, 1993
- A Study of the Autoignition Process of a Diesel Spray via High Speed VisualizationSAE International Journal of Advances and Current Practices in Mobility, 1992