Foam formation in gas‐assisted injection molded parts: Theoretical and experimental considerations
Authors:
- 1 August 1996
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 36 (16) , 2163-2171
Abstract
This article is concerned with a physico‐mathematical model to describe the foaming phenomenon in gas‐assisted injection molded parts. The investigations have been conducted on polycarbonate grades to begin with. When parts are produced by gas injection molding, foam has the effect of weakening the residual wall thickness and also of impairing optical quality. It would thus be an advantage if a parameter constellation could be defined in advance, which would ensure the suppression of foam formation.Keywords
This publication has 6 references indexed in Scilit:
- Bubble nucleation in polymeric liquids. II. theoretical considerationsJournal of Polymer Science Part B: Polymer Physics, 1990
- The nucleation of microcellular thermoplastic foam with additives: Part I: Theoretical considerationsPolymer Engineering & Science, 1987
- Engineering Mathematics1977
- Bubble nucleation in liquidsAIChE Journal, 1975
- Nucleation and growth of bubbles in elastomersJournal of Polymer Science Part A-2: Polymer Physics, 1970
- Diffusion and solution of gases into thermally softened or molten polymers: Part II. Relation of diffusivities and solubilities with temperature pressure and structural characteristicsAIChE Journal, 1969