Process parameterization and temporal scaling in surface runoff and erosion modelling
Authors:
- 17 May 2004
- journal article
- research article
- Published by Wiley in Hydrological Processes
- Vol. 18 (8) , 1423-1446
Abstract
It is common for runoff and erosion models to be run at coarse time steps (e.g. daily) owing to limited data availability. However, such models are unable to capture adequately the small‐scale surface runoff and erosion processes that are dominated by, for example, precipitation characteristics at time‐scales of minutes. This dilemma calls for the development of approaches that appropriately capture short time‐scale processes when running the models at daily scales. In this paper, we assess two scaling approaches that are simple and are intended to preserve prediction quality as time scales become coarser: (i) use of effective rates of precipitation and runoff, and (ii) use of a rainfall disaggregation scheme. Runoff and erosion are simulated using a six‐parameter surface runoff model and a one‐parameter erosion model. A downhill simplex optimization algorithm is applied for parameterization at 2 min and daily time steps, using measured 2 min and daily precipitation data respectively, against measured daily runoff and erosion. The 2 min simulation results are aggregated to daily values to make comparisons with the measured plot‐scale daily runoff and erosion data for 2 years (1997–98) from six sites in the Jhikhu Khola catchment in Nepal. The runoff and erosion simulation results calibrated from the 2 min precipitation data are good (E = 0·92 for runoff and 0·80 for erosion, all sites collectively), whereas other results, particularly the erosion simulation from the calibrated daily model, are very poor. These results are taken as the reference to compare with the two different scaling approaches. The effective rate approach is poor compared with the 2 min estimates but is a considerable improvement over daily erosion estimates. The rainfall disaggregation scheme is comparable to the 2 min estimates and produces better results than the effective rate approach. This study illustrates that rainfall scaling has significant scope for temporal scaling of hydrologic processes, particularly where continuous simulation is preferred. Copyright © 2004 John Wiley & Sons, Ltd.Keywords
This publication has 50 references indexed in Scilit:
- Disaggregation of daily rainfall by conditional simulation from a point-process modelJournal of Hydrology, 2003
- Rainfall disaggregation using adjusting procedures on a Poisson cluster modelJournal of Hydrology, 2001
- Multiscaling properties of rainfall and bounded random cascadesWater Resources Research, 1997
- Temporal scales and hydrological regimes: Implications for flood frequency scalingWater Resources Research, 1997
- On the applicability of Bartlett–Lewis rectangular pulses models in the modeling of design storms at a pointJournal of Hydrology, 1997
- Flood frequency prediction for data limited catchments in the Czech Republic using a stochastic rainfall model and TOPMODELJournal of Hydrology, 1997
- An investigation into the physical causes of scaling and heterogeneity of regional flood frequencyWater Resources Research, 1997
- Stochastic point process modelling of rainfall. I. Single-site fitting and validationJournal of Hydrology, 1996
- Sensitivity analysis of the Systeme Hydrologique Europeen for an upland catchmentJournal of Hydrology, 1986
- River flow forecasting through conceptual models part I — A discussion of principlesJournal of Hydrology, 1970